ICOM 318200 Manuale Utente

PRECAUTIONS

R WARNING HIGH RF VOLTAGE! NEVER

 

attach an antenna or internal antenna connector 
during transmission. This may result in an electrical 
shock or burn.

R WARNING! NEVER 

operate the transceiver 

with a headset or other audio accessories at high 
volume levels. Hearing experts advise against continu-
ous high volume operation. If you experience a ringing 
in your ears, reduce the volume or discontinue use.

R WARNING! NEVER

  operate or touch the 

transceiver with wet hands. This may result in an 
electric shock or damage to the transceiver.

R WARNING! NEVER

 apply AC power to the 

[DC13.8V] socket on the transceiver rear panel. This 
could cause a fire or damage the transceiver.

R WARNING! NEVER

 apply more than 16 V 

DC to the [DC13.8V] socket on the transceiver rear 
panel,  or use reverse polarity. This could cause a fire 
or damage the transceiver.

R WARNING! NEVER

 let metal, wire or other 

objects protrude into the transceiver or into connectors 
on the rear panel. This may result in an electric shock.

R WARNING! 

Immediately turn OFF the trans-

ceiver power and remove the power cable if it emits 
an abnormal odor, sound or smoke. Contact your 
Icom dealer or distributor for advice.

 put the transceiver in any 

unstable place (such as on a slanted surface or 
vibrated place). This may cause injury and/or damage 
to the transceiver.

 

change the internal settings of 

the transceiver. This may reduce transceiver perfor-
mance and/or damage to the transceiver.

In particular, incorrect settings for transmitter circuits, 
such as output power, idling current, etc., might 
damage the expensive final devices.

The transceiver warranty does not cover any prob-
lems caused by unauthorized internal adjustment.

#!54)/. NEVER

  block any cooling vents on 

the top, rear, sides or bottom of the transceiver.

#!54)/. NEVER

 expose the transceiver to 

rain, snow or any liquids.

#!54)/. NEVER

  install the transceiver in a 

place without adequate ventilation. Heat dissipation 
may be reduced, and the transceiver may be damaged.

  use harsh solvents such as benzine or 

alcohol when cleaning, as they will damage the trans-
ceiver surfaces.

 push the PTT switch when you don’t actu-

ally desire to transmit.

 use or place the transceiver in areas with 

temperatures below ±0°C (+32°F) or above +50°C 
(+122°F).

 place the transceiver in excessively dusty 

environments or in direct sunlight.

 place the transceiver against walls or 

putting anything on top of the transceiver. This may 
overheat the transceiver.

Always place unit in a secure place to avoid inadver-
tent use by children.

 If you use a linear amplifier, set 

the transceiver’s RF output power to less than the 
linear amplifier’s maximum input level, otherwise, the 
linear amplifier will be damaged.

 The rear panel will become hot 

when operating the transceiver continuously for long 
periods of time.

USE only the specified microphone. Other manufac-
turers’ microphones have different pin assignments, 
and connection to the IC-7410 may damage the 
transceiver or microphone.

During maritime mobile operation, keep the trans-
ceiver and microphone as far away as possible from 
the magnetic navigation compass to prevent errone-
ous indications.

Turn OFF the transceiver’s power and/or disconnect 
the DC power cable when you will not use the trans-
ceiver for long period of time.

ii