ICOM 325000 Manuale Utente
V
QUICK REFERENCE GUIDE
N Programmed scan operation
25 pairs, 50 channels of memories are used for programmed
scan operation, that specifies a scanning ranges. The pro-
grammed scan scans between “xxA” and “xxB” (xx=00 to 24)
frequencies. Therefore, before operating the programmed
scan, different frequencies must be programmed into “A” and
“B” scan edge channels.
scan operation, that specifies a scanning ranges. The pro-
grammed scan scans between “xxA” and “xxB” (xx=00 to 24)
frequencies. Therefore, before operating the programmed
scan, different frequencies must be programmed into “A” and
“B” scan edge channels.
D Programming scan edges
A start frequency must be programmed into a “xxA,” and end
frequency must be programmed into a “xxB” memory chan-
nel.
frequency must be programmed into a “xxB” memory chan-
nel.
1. Setting frequency
In the VFO mode, set a desired receive frequency selection
mode.
mode.
• When the “
” icon is displayed, push [V/M] to select the VFO
mode.
2. Selecting a scan edge “A” channel
Hold down [S.MW](V/M) for 1 second, then rotate [DIAL] to
select one of the 25 scan edge “A” channels.
select one of the 25 scan edge “A” channels.
• The “
” icon and scan edge channel number blink.
3. Writing a memory channel
Hold down [S.MW](V/M) for 1 second until 3 beeps sound.
• The paired scan edge “B” channel is automatically selected when
holding down [S.MW](V/M) after programming.
• When programming is completed, return to the VFO mode.
4. Selecting a scan edge “B” channel
Hold down [S.MW](V/M) for 1 second, then rotate [DIAL] to
select one of the 25 scan edge channel “B.”
select one of the 25 scan edge channel “B.”
• The “
” icon and the scan edge channel number blink.
• When the scan edge “B” channel is already selected in step 3. (by
holding down [S.MW](V/M) after programming), skip this step.
5. Writing a memory channel
Hold down [S.MW](V/M) for 1 second until 3 beeps sound.
• The next scan edge “A” channel is automatically selected when
holding down [S.MW](V/M) after programming.
• When programming is completed, return to the VFO mode.
Quic
k ref
erence guide