ICOM 325000 Manuale Utente
18
5
MEMORY CHANNELS
4
5
N General description
The receiver has
1350
memory channels, including 50 scan
edge memory channels (25 pairs) for storage of often-used
frequencies. A total of 18 memory banks, A to R, T, U, W and
Y can be selected. Up to 100 channels can be assigned to
each bank.
frequencies. A total of 18 memory banks, A to R, T, U, W and
Y can be selected. Up to 100 channels can be assigned to
each bank.
D Memory channel contents
The following information can be programmed into memory
channels:
channels:
• Receive frequency
(p. 9)
• Receive mode
(p. 12)
• Duplex direction
(+DUP or –DUP)
with a frequency offset
(p. 14)
• Tone squelch or DTCS squelch ON/OFF
(p. 35)
• Tone squelch frequency or DTCS code with polarity
(pp.
36, 37)
• Scan skip setting
(p. 30)
• Memory bank
(p. 95)
• Memory name
(p. 97)
• Tuning step
(p. 22)
N Selecting a memory channel
q Push [V/M] to select the memory mode.
• Push [V/M] to toggle between the VFO mode and the memory
channel mode.
w Rotate [DIAL] to select a desired memory channel.
• Only programmed channels are displayed.
• While holding down [FUNC], rotate [DIAL] to select the memory
• While holding down [FUNC], rotate [DIAL] to select the memory
channel in 10 channel steps.
Appears
Rotate [DIAL] to select
the memory channel.
the memory channel.
NOTE: Memory data can be erased by static electricity,
electric transients, etc.
In addition, it can be erased by malfunction and during
repairs. Therefore, we recommend that memory data be
written down or saved to a PC using the CS-R6
electric transients, etc.
In addition, it can be erased by malfunction and during
repairs. Therefore, we recommend that memory data be
written down or saved to a PC using the CS-R6
CLONING
SOFTWARE
.