ICOM 325000 Manuale Utente
N Preparation
D Battery installation
q Remove the battery
cover from the receiver.
w Install 2 R6(AA) size
Ni-MH or alkaline cell
batteries.
batteries.
• Be sure to observe the
correct polarity.
• Charge the Ni-MH bat-
teries before use. (See
p.III for charging instruc-
tions.)
p.III for charging instruc-
tions.)
Keep the battery terminals clean. It’s a good idea to clean
the battery terminals once a week.
the battery terminals once a week.
D Belt clip
Conveniently attaches to
your belt.
your belt.
Slide the belt clip into the
plastic loop on the back of
the receiver.
plastic loop on the back of
the receiver.
D Antenna
Insert the antenna connector into
the antenna base and tighten the
antenna screw.
the antenna base and tighten the
antenna screw.
• NEVER carry the receiver by
holding only the antenna.
• When the jack is not in use,
keep the jack cover attached
to protect the connectors from
dust and moisture.
to protect the connectors from
dust and moisture.
For your information
Third-party antennas may increase receiver performance.
An optional AD-92SMA
Third-party antennas may increase receiver performance.
An optional AD-92SMA
ANTENNA CONNECTOR ADAPTER
is
available to connect an antenna with a BNC connector.
D Handstrap
To facilitate carrying the receiver,
slide the hand strap through the
loop on the top of the belt clip.
slide the hand strap through the
loop on the top of the belt clip.
Latch
I
QUICK REFERENCE GUIDE
Quic
k ref
erence guide