ICOM 325300 Manuale Utente

65

10

DTMF codes are used for autopatching, accessing repeat-
ers, controlling other equipment, etc. The transceiver has 16
DTMF memory channels (d0–d9, dA, db, dC, dd, dE, dF) for 
storage of often-used DTMF codes of up to 24 digits.

q  Push [SET] to enter the Set mode.

w  Rotate [DIAL] to select the DTMF programming item.

e  Rotate [VOL] to select a desired DTMF memory channel.

• If programmed, previously programmed DTMF code is dis-

played.

[VOL]

[DIAL]

DTMF memory channel

Blank channel indication

r  Push and hold [SET] for 1 sec. to enter the programming 

mode.

The cursor is blinking during
programming mode.

t  Rotate [VOL] to select the char-

acters.

• “0”–“9,” “A,” “b,” “C,” “d,” “E” and “F” 

are selectable.

• Up to 24 digits can be programmed.
• Push  [BAND]  to move the cursor 

right; push [SET] to move the cur-
sor left.

y  Repeat step t until the desired code is input.

Next display appears after 6th digit has been input.

: 1st display

: 2nd display

: 3rd display

: 4th display

• If a digit is mistakenly programmed, push [SET] (or [BAND]) re-

peatedly to select the digit, then rotate [VOL] to correct it.

Or rotate [VOL] to select “_” to erase on and after the digits. Pro-
grammed memories will be cleared by this operation on the 1st 
digit.

y  Push [BAND] twice to program the DTMF code and exit 

the programming mode.

• After the 24th digit is input, the transceiver automatically stores 

the code sequence and returns to step 

e.

uPush [V/M/C] to return to the frequency display.

N Programming a DTMF code sequence

[VOL]