ICOM 332902 Manuale Utente

12

■

Prior to using the transceiver for the first time, the battery pack 
must be fully charged for optimum life and operation. (p. 31)

➥

Rotate [VOL] to turn power ON.

D Battery type selection

The battery type must be selected according to the battery pack or 
case when it is changed, but only the first time it is used.
Check the battery type before you begin the selection procedure.
One to three beep(s) sound in sequence, so you must repeat the 
steps until the number of beeps matches your battery type.
For example, if your battery type is a Li-ion battery pack, you must 
repeat the procedure until one beep is heard.

q

  Set  [ROTARY  SELECTOR]  to  any 

channel other than Channel 16.

w  

Rotate [VOL] to turn OFF the trans-
ceiver’s power.

e  

While  holding  down  [PTT],  rotate 
[VOL] to turn ON the power.

 • You should hold [PTT] until the beep

sounds.  (It  takes  approximately  5 
second.)

 • One  beep  sounds  when  the  Li-ion

battery is selected.

 • Two beeps sound when the battery case is selected.
 • Three beeps sound when the Ni-MH battery is selected.

r

 After the beep sounds, release [PTT].

t 

Repeat steps w to r until you select the attached battery type.
NOTE: This operation may not be available, depending on the 
presetting. Ask your dealer for details.