ICOM 333202 Manuale Utente

14

2

BASIC OPERATION

■

The dispatcher can send a 2/5-tone signal that will stun, kill
or revive your transceiver. 

When the Stun ID is received, a beep sounds*, and the trans-
ceiver becomes unusable. Receiving a Revive command or 
entering password* (p. 8) is necessary to operate the trans-
ceiver again in this case.
When the Kill ID is received, a beep sounds*, and the trans-
ceiver becomes unusable (the transceiver switches to the 
cloning required condition). Cloning the transceiver is neces-
sary to operate the transceiver again in this case.
*  Depending on the preprogramming. Ask your dealer for de-

tails.

  See the operating guide for details of the Stun function 

with the MDC and Digital system operations. Ask your 
dealer for details.

■

When  the  transceiver  has  a  key  assigned  to  Power  OFF 
Emergency, you can use the function.
This  function  makes  the  transceiver  transmit  emergency 
calls, even though it appears to be powered OFF.

To activate the Power OFF Emergency function, turn the 
power OFF while holding down [Power OFF Emergency].
When the function is activated, any key operation, the ON/
OFF Hook and Lone Worker functions become invalid. The 
beep, display and speaker are turned OFF as well.
On the other hand, the transceiver can transmit emergency 
calls according to the pre-programmed emergency settings.
Depending  on  the  pre-programmed  settings,  the  Remote 
Monitor function can also be used (digital operation only).
To cancel the Power OFF Emergency function and restore 
the transceiver, turn the power ON.

■

When one of the following operations is performed, the trans-
ceiver automatically selects the Priority A channel.

• Turning ON the power
   The Priority A channel is selected each time the transceiver 

power is turned ON.

• Auto Reset
   The Priority A channel is selected when the Auto Reset 

timer ends.

• OFF hook
   The Priority A channel is selected when you take the micro-

phone OFF hook.