ICOM 361500 Manuale Utente
1-10
1
PANEL DESCRIPTION
^5
LOCK KEY [LOCK]
(p. ?5-19)
Push to switch the dial lock function ON or OFF.
^6
QUICK TUNING KEY [TS]
➥
Turns the quick tuning step ON or OFF. (p. ?3-6)
• While the quick tuning indicator, “Z
,” is displayed
above the frequency indication, the frequency can
be changed in programmed kHz steps.
be changed in programmed kHz steps.
• 0.1, 1, 5, 9, 10, 12.5, 20 and 25 kHz steps are avail
-
able for each operating mode independently.
➥
When the quick tuning step is OFF, held down
for 1 second to turn the 1 Hz tuning step ON or
OFF. (p. ?3-7)
➥
When the quick tuning step is ON, hold down
for 1 second to enter the Quick tuning step set
for 1 second to enter the Quick tuning step set
screen. (p. ?3-6)
^7
CLEAR KEY [CLEAR]
(pp. ?5-11, 6-4)
Clears the RIT/∂TX shift frequency when held down
for 1 second or when pushed momentarily, depend-
ing on the quick RIT/∂TX clear function setting
(p.
?12-18)
.
^8
∂TX KEY [∂TX]
(p. ?6-4)
➥
Turns the
∂TX function ON or OFF when
pushed.
• Use [RIT/∂TX] control to vary the ∂TX frequency.
➥
Adds the
∂TX shift frequency to the operating
frequency when held down for 1 second.
✔
What is the ∂TX function?
∂TX shifts the transmit frequency without shifting the receive
frequency. This is useful for simple split frequency operation
in CW, etc.
frequency. This is useful for simple split frequency operation
in CW, etc.
^9
RIT KEY [RIT]
(p. ?5-11)
➥
Turns the RIT function ON or OFF when
pushed.
• Use [RIT/∂TX] control to vary the RIT frequency.
➥
Adds the RIT shift frequency to the operating fre
-
quency when held down for 1 second.
✔
What is the RIT function?
Receiver incremental tuning (RIT) shifts the receive fre
-
quency without shifting the transmit frequency.
This is useful for fine tuning stations calling you on off-fre-
quency or when you prefer to listen to slightly different-
sounding voice characteristics, etc.
&0
CW PITCH CONTROL [CW PITCH]
(p. ?4-5)
Shifts the received CW audio pitch and the CW
side tone pitch without changing the operating fre-
quency.
&1
MANUAL NOTCH FILTER CONTROL [NOTCH]
(p. ?5-20)
Varies the “valley” frequency of the manual notch
filter to reject an interfering signal while the manual
notch function is ON.
• Notch filter center frequency:
SSB : –1060 Hz to 4040 Hz
CW : CW pitch freq. + 2540 Hz to CW pitch freq.
SSB : –1060 Hz to 4040 Hz
CW : CW pitch freq. + 2540 Hz to CW pitch freq.
–2540 Hz
AM : –5100 Hz to 5100 Hz
■
Front panel (Continued)
&5
&4
&2
&3
&1
&0
^7
^8
^9
^6
^5