ICOM 369700 Manuale Utente

 The transceiver will become hot when 

operating continuously for long periods.

 the specified microphone only. Other microphones have 

different pin assignments and may damage the transceiver.

Place the transceiver in a secure place to avoid inadvertent use by 

children.

 the transceiver away from the heavy rain, and never 

immerse it in the water. The transceiver meets IP54* requirements 

for dust-protection and splash resistance. However, once the 

transceiver has been dropped, dust protection and splash 

resistance cannot be guaranteed due to the fact that the transceiver 

may be cracked, or the waterproof seal damaged, and so on.

*Only when the supplied microphone is attached.

Icom, Icom Inc. and Icom logo are registered trademarks of Icom 

Incorporated (Japan) in Japan, the United States, the United Kingdom, 

Germany, France, Spain, Russia, Australia, New Zealand, and/or other 

countries.
The Bluetooth word mark and logos are registered trademarks owned by 

Bluetooth SIG, Inc. and any use of such marks by Icom inc. is under license. 

All other products or brands are registered trademarks or trademarks of their 

respective holders.

ii

PRECAUTIONS

R 

 connect the transceiver to an AC 

outlet. This may pose a fire hazard or result in an electric shock.

R 

 connect the transceiver to a power 

source of more than 31.5 V DC. This could damage the transceiver.

R 

 cut the DC power cable between 

the DC plug and fuse holder. If an incorrect connection is made 

after cutting, the transceiver might be damaged.

R 

 place the transceiver where normal 

operation of the vehicle may be hindered or where it could cause 

bodily injury.

CAUTION: NEVER

 expose the transceiver to rain, snow or 

any liquids.

 operate or place the transceiver in areas with 

temperatures below –30°C (–22°F) or above +60°C (+140°F), or in 

areas subject to direct sunlight, such as the dashboard.

 operate the transceiver without running the vehicle’s 

engine. The vehicle’s battery will quickly run out when the 

transceiver transmits while the vehicle’s engine is OFF.

 place the transceiver in excessively dusty 

environments.

 place the transceiver against walls. Otherwise heat 

dissipation will be obstructed.

 use harsh solvents such as benzine or alcohol when 

cleaning, as they damage the transceiver surfaces.

CAUTION: In Canada, use of 8.33 kHz Channel Spacing of this 

radio is strictly prohibited and shall not be used.