ICOM 370500 Manuale Utente
4
8
MAINTENANCE
n
Troubleshooting
The following chart is designed to help you correct
problems which are not equipment malfunctions.
problems which are not equipment malfunctions.
If you are unable to locate the cause of a problem
or solve it through the use of this chart, contact your
nearest Icom Dealer or Service Center.
or solve it through the use of this chart, contact your
nearest Icom Dealer or Service Center.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
PROBLEM
POSSIBLE CAUSE
SOLUTION
REF.
Power does not come
on when
on when
[POWER] is
pushed.
• DC power cable is improperly connected.
• Fuse is blown.
• Re-connect the DC power cable correctly.
• Check for the cause, then replace the fuse
with a spare one.
pp.
5, 6
p. 8
5, 6
p. 8
No sound comes from
the speaker.
the speaker.
• Volume level is too low.
• The squelch is closed.
• The audio mute function is activated.
• A selective call or squelch function is acti-
vated such as 5-tone call or tone squelch.
• The front speaker is set to OFF.
• Rotate
[VOLUME] clockwise to obtain a suit-
able listening level.
• While in base operating mode, rotate
[SE-
LECT] to counterclockwise to open the
squelch. (When the [SQL Level Up/Down] key
function is assigned to
squelch. (When the [SQL Level Up/Down] key
function is assigned to
[SELECT].)
• Push
[MONI] (if assigned) to turn the audio
mute function OFF.
• Turn the appropriate function OFF.
• Turn the front speaker ON using the optional
CS-FR5000
cloning
software
. Ask your
dealer for details.
p. 7
p. 7
–
–
–
Sensitivity is low and
only strong signals
are audible.
only strong signals
are audible.
• Antenna feedline or the antenna connec-
tor has a poor contact or is short-circuited.
• Check and re-connect (or replace if neces-
sary), the antenna feedline or antenna con-
nector.
nector.
p. 5
Received audio is un-
clear or distorted.
clear or distorted.
• Optional voice scrambler is turned OFF.
• Scrambler code is not set correctly.
• Scrambler code is not set correctly.
• Turn the optional voice scrambler ON.
• Reset the scrambler code.
• Reset the scrambler code.
–
–
–
Output power is too
low.
low.
• Output power is set to Low.
• Power amplifier protection circuit is acti-
vated.
• Push
[HIGH/LOW] (if assigned) to select the
High power.
• Cool down the repeater or stop accessing to
the repeater until it has cooled down.
–
–
No contact possible
with another station.
with another station.
• The other station is using tone squelch.
• While in base operating mode, the re-
• While in base operating mode, the re-
peater is set to duplex.
• Turn the tone squelch function ON.
• Set the repeater to simplex, when other trans-
• Set the repeater to simplex, when other trans-
ceiver is set to simplex.
–
–
–