ICOM 381500 Manuale Utente

Pagina di 2
A-7318?-1EX
© 2016  Icom Inc.
1-1-32 Kamiminami, Hirano-ku, Osaka 547-0003, Japan
FCC and IC information
• FOR CLASS B UNINTENTIONAL RADIATORS:
This equipment has been tested and found to comply with 
the limits for a Class B digital device, pursuant to part 15 of 
the FCC Rules. These limits are designed to provide reason-
able protection against harmful interference in a residential 
installation. This equipment generates, uses and can radiate 
radio frequency energy and, if not installed and used in ac-
cordance with the instructions, may cause harmful interfer-
ence to radio communications. However, there is no guaran-
tee that interference will not occur in a particular installation. 
If this equipment does cause harmful interference to radio or 
television reception, which can be determined by turning the 
equipment off and on, the user is encouraged to try to correct 
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
•  Increase the separation between the equipment and re-
ceiver.
•  Connect the equipment into an outlet on a circuit differ-
ent from that to which the receiver is connected.
•  Consult the dealer or an experienced radio/TV techni-
cian for help.
CAUTION: Changes or modifications to this device, not 
expressly approved by Icom Inc., could void your authority 
to operate this device under FCC regulations.
This device complies with Part 15 of FCC and Industry Can-
ada licence-exempt RSS standard(s). Operation is subject to 
the following two conditions: (1) this device may not cause in-
terference, and (2) this device must accept any interference, 
including interference that may cause undesired operation 
of the device.
This transmitter must not be co-located or operated in con-
junction with any other antenna or transmitter. 
CAN ICES-3 (B)
Le présent appareil est conforme aux la partie 15 des règles 
de la FCC et CNR d'Industrie Canada applicables aux ap-
pareils radio exempts de licence. L'exploitation est autori-
sée aux deux conditions suivantes: (1) l'appareil ne doit pas 
produire de brouillage, et (2) l'utilisateur de l'appareil doit ac-
cepter tout brouillage radioélectrique subi, même si le brouil-
lage est susceptible d'en compromettre le fonctionnement.
Cet émetteur ne doit pas être co-localisé ou fonctionner en 
conjonction avec une autre antenne ou émetteur.
NMB-3 (B)
• For Mobile Use
This equipment complies with FCC/IC radiation exposure 
limits set forth for an uncontrolled environment and meets 
the FCC radio frequency (RF) Exposure Guidelines and 
RSS-102 of the IC radio frequency (RF) Exposure rules. This 
equipment has very low levels of RF energy that it deemed 
to comply without maximum permissive exposure evaluation 
(MPE).
Cet équipement est conforme aux limites d’exposition aux 
rayonnements énoncées pour un environnement non con-
trôlé et respecte les règles les radioélectriques (RF) de 
la FCC lignes directrices d’exposition et d’exposition aux 
fréquences radioélectriques (RF) CNR-102 de l’IC. Cet équi-
pement émet une énergie RF très faible qui est considérée 
conforme sans évaluation de l’exposition maximale autori-
sée.
• For Portable Use
This equipment complies with FCC/IC radiation exposure 
limits set forth for an uncontrolled environment and meets 
the FCC radio frequency (RF) Exposure Guidelines and 
RSS-102 of the IC radio frequency (RF) Exposure rules. This 
equipment has very low levels of RF energy that are deemed 
to comply without testing of specific absorption ratio (SAR).
Cet équipement est conforme aux limites d’exposition aux 
rayonnements énoncées pour un environnement non con-
trôlé et respecte les règles les radioélectriques (RF) de 
la FCC lignes directrices d’exposition et d’exposition aux 
fréquences radioélectriques (RF) CNR-102 de l’IC. Cet équi-
pement émet une énergie RF très faible qui est considérée 
conforme sans évaluation du débit d’absorption spécifique 
(DAS).
 Versions of the UT-136 which display the “CE” 
symbol on the serial number label, comply with 
the essential requirements of the Radio and 
Telecommunications Terminal Equipment 
Directive, 1999/5/EC, and the restriction of the 
use of certain hazardous substances in 
electrical and electronic equipment Directive, 
2011/65/EU.
You can get the DOC (Declaration Of Conformity) from your 
nearest Icom dealer. See the Icom website for details of 
your nearest dealer.
http://www.icom.co.jp/world/
About CE
After installing the Bluetooth
®
 unit, place the
 
below
 
FCC/IC ID label on the outside of the transceiver.
Disposal
The crossed-out wheeled-bin symbol on your 
product, literature, or packaging reminds 
you that in the European Union, all electrical 
and electronic products, batteries, and 
accumulators (rechargeable batteries) must be 
taken to designated collection locations at the 
end of their working life. Do not dispose of these products 
as unsorted municipal waste. Dispose of them according to 
the laws in your area.
The module does not have a shielding. this module is designed for installing inside Grantee's 
host radio, shielding in host will be implemented to prevent coupling between the RF circuitry 
of the module and any wires or circuits in the device into which the module is installed.
Module does not have its own power supply regulation. The module will be professional installed in 
Grantee host devices and power regulation will be regulated by the host device and will be verified 
to comply with Part 15 requirements.