ICOM IC-703 Manuale Utente

2

12

INSTALLATION AND CONNECTIONS

To raise the stand:
With the transceiver upside down, pull the stand to-
wards the rear panel and then upwards, as illus-
trated below. 

■Installation

DSingle body mounting

DStand

Nut

Spring washer

Flat washer

*CAUTION: Non-supplied screws (longer than 8 mm)

may damage the internal units.

MB-62
(optional)

Supplied with
the MB-62*

Pull back

then up

DFront panel separation

DFront panel mounting

qWhile pulling the panel release button towards you,

slide the front panel to the right (fig. 1).

wAttach the optional OPC-581 to the main body and

tighten the supplied screw as in fig. 2.

eAttach the other end of the OPC-581 to the de-

tached front panel as in fig. 3.

NEVER detach/attach the front panel

when connecting the DC power supply (or battery).
Make sure the disconnecting DC power cable from
the [13.8 V] receptacle on the transceiver rear
panel.

qAttach the MB-63 to a flat surface using the two

supplied screws (fig. 1).

wFix the detached front panel to the MB-63 as illus-

trated in fig. 2.

BE CAREFUL of the orientation of the MB-63, oth-
erwise, the front panel may become attached in the
opposite direction.

fig. 1

fig. 2

fig. 3

Latch

Separation cable

Separation cable

fig. 1

fig. 2