ICOM IC-F620-2 Manuale Utente
7
2
OPERATION
■Turning power ON
q Push [K
I
] to turn the power ON.
• A power-up alert tone sounds for about 1 sec. and an opening
message may appear.
w If the transceiver is programmed for a start up passcode,
input digit codes as directed by your System operator.
• The keys in the diagram below can be used for password input:
• The transceiver detects numbers in the same block as identical.
• The transceiver detects numbers in the same block as identical.
Therefore “01234” and “56789” are the same.
e When the “
PASSWORD
” indication does not clear after
inputting 4 digits, the input code number may be incorrect.
Turn power off and start over in this case.
Turn power off and start over in this case.
■Channel selection
Several types are available, and the channel selection
method may differ according to your system set up.
method may differ according to your system set up.
NON-BANK TYPE:
Push the
Push the
[CH Up]
/
[CH Down]
keys to select the desired oper-
ating channel, in sequence; or,
push one of the [
push one of the [
CH 1
] to [
CH 4
] keys to select these channels
directly.
BANK-TYPE:
Push [
Push [
BANK
] to select the desired bank number.
AUTOMATIC SCAN TYPE:
Channel setting is not necessary for this type. When turning
the power ON, the transceiver automatically starts scanning.
Scanning stops when receiving a call or when taking the
microphone off hook.
Channel setting is not necessary for this type. When turning
the power ON, the transceiver automatically starts scanning.
Scanning stops when receiving a call or when taking the
microphone off hook.
KEY
[P0]
[P1]
[P2]
[P3]
[P4]
NUMBER
0
1
2
3
4
5
6
7
8
9
00 IC-F610EUR.qxd 01.11.28 11:37 AM Page j (1,1)