ICOM IC-F621-2 Manuale Utente
17
4
CONNECTION AND MAINTENANCE
■
Optional UT-105 and UT-108
installation
installation
The optional UT-105 and UT-108 units install as follows:
q
Turn power OFF, then disconnect the DC power cable.
w
Unscrew the 4 screws, then remove the bottom cover.
e
Install the unit as shown in the diagram below.
r
Replace the bottom cover and screws, then the DC power
cable.
cable.
■
Optional UT-109 /UT-110
installation
q
Turn power OFF, then disconnect the DC power cable.
w
Unscrew the 4 screws, then remove the bottom cover.
e
Cut the print pattern on the PCB at the TX mic circuit (A)
and RX AF circuit (B) as shown in the following figure.
and RX AF circuit (B) as shown in the following figure.
r
Install the scrambler unit as shown in the left.
t
Return the bottom cover and screws to the original posi-
tion.
tion.
NOTE: Be sure to re-solder
above disconnected points, oth-
erwise no TX modulation or AF
output is available when you
remove the scrambler units.
above disconnected points, oth-
erwise no TX modulation or AF
output is available when you
remove the scrambler units.
A
B
Front panel
IC-F510F520_F610F620.qxd 02.1.21 10:03 AM Page t (1,1)