ICOM IC-R75 Manuale Utente
RWARNING NEVER
apply AC to the [DC13.8V]
jack on the receiver rear panel. This could cause a fire
or ruin the receiver.
or ruin the receiver.
RWARNING NEVER
apply more than 16 V DC,
such as a 24 V battery, to the [DC13.8V] jack on the
receiver rear panel. This could cause a fire or ruin the
receiver.
receiver rear panel. This could cause a fire or ruin the
receiver.
RWARNING NEVER
let metal, wire or other
objects touch any internal part or connectors on
the rear panel of the receiver. This may result in an
electric shock.
the rear panel of the receiver. This may result in an
electric shock.
NEVER
expose the receiver to rain, snow or any
liquids.
DO NOT use or place the receiver in areas with
temperatures below –10°C (+14°F) or above +60°C
(+140°F). Be aware that temperatures on a vehicle’s
dashboard can exceed 80°C (+176°F), resulting in
permanent damage to the receiver if left there for
extended periods.
temperatures below –10°C (+14°F) or above +60°C
(+140°F). Be aware that temperatures on a vehicle’s
dashboard can exceed 80°C (+176°F), resulting in
permanent damage to the receiver if left there for
extended periods.
DO NOT place the receiver in excessively dusty
environments or in direct sunlight.
environments or in direct sunlight.
DO NOT place the receiver against walls or putting
anything on top of the receiver. This will obstruct heat
dissipation.
anything on top of the receiver. This will obstruct heat
dissipation.
Place unit in a secure place to avoid inadvertent use by
children.
children.
During mobile operation,
DO NOT operate the receiver
without running the vehicle’s engine. When receiver
power is ON and your vehicle’s engine is OFF, the
vehicle’s battery will soon become exhausted.
power is ON and your vehicle’s engine is OFF, the
vehicle’s battery will soon become exhausted.
Make sure the receiver power is OFF before starting
the vehicle. This will avoid possible damage to the
receiver by ignition voltage spikes.
the vehicle. This will avoid possible damage to the
receiver by ignition voltage spikes.
For U.S.A only
CAUTION: Changes or modifications not expressly
approved by the party responsible for compliance
could void the user's authority to operate the
equipment.
CAUTION: Changes or modifications not expressly
approved by the party responsible for compliance
could void the user's authority to operate the
equipment.
PRECAUTIONS
ii
FOR CLASS B UNINTENTIONAL RADIATORS
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Versions of the IC-R75 which display the “CE” symbol on the serial number label comply with the
European harmonised standard ETS300 684 (EMC product standard for Commercially Available
Amateur Radio Equipment).
European harmonised standard ETS300 684 (EMC product standard for Commercially Available
Amateur Radio Equipment).