CEI Conrad Electronic International Limited RCE-NOVAX350 Manuale Utente

Safety Instructions  |  13

> Before every flight, check the functional reliability of your model and the transmitter.

Watch out for any visible damage such as defective plug connections or damaged
cables and wires.

> All moving parts of the model must run smoothly but should not have any play in their

bearings.

> Before each operation check the correct and secure position of the propellers.

> Charge the flight battery according to the steps provided in chapter

‘24. canopy’ on

. Ensure sufficient residual capacity [ battery tester (not included) ] of the

batteries  inserted  in  the  transmitter.  If  the  batteries  are  empty,  always  replace  the
complete set, never individual cells only.

> Always switch on the transmitter first before connecting the battery to the »NovaX 350.

> Set the throttle to zero before connecting the battery to the »NovaX 350. The rotors

 

might run unintentionally!

> When the rotors are running, make sure that neither objects nor body parts are in the

rotating and suction area of the propellers.

> Do not take any risks when operating the model! Your own safety and that of your

environment is solely down to you being responsible when dealing with the model.

> Improper operation may cause serious injury and property damage! Therefore make

sure to keep a sufficiently safe distance to persons, animals or objects during operation.

> Select an appropriate location for the operation of the »NovaX 350.

> Fly the »NovaX 350 only if your ability to respond is unrestricted. The influence of

tiredness, alcohol or medication can cause incorrect responses.

> Do not direct your model towards spectators or yourself.

> Motor, electronics and flight battery may heat up during operation. Wait 5 to 10 minutes

before recharging or replacing the flight battery.

> Never  switch  off  the  transmitter  while  the  »NovaX  350  is  in  use. After  landing,  always

disconnect the flight battery first. Only then may the transmitter be switched off.

> In case of a defect or a malfunction, remove the problem before using the »NovaX 350

again.

> Never expose the »NovaX 350 or the transmitter to direct sunlight or excessive heat for

an extended period of time.

> In the case of a severe crash (e.g. from a high altitude) the electric gyro sensors can be

damaged and/or misadjusted. Therefore, full functionality must be tested before flying
again without fail!

> In  the  event  of  a  crash,  the  throttle  should  be  immediately  set  to  zero.  Rotating

propellers may be damaged if they come into contact with obstacles. Before flying
again, these should be checked for possible tears or breakages!

> Observe  the  warn/safety  signals  emitted  by  the  »NovaX  350  at  all  times  to  avoid

damage (e.g. discharged battery).

> Always and only operate the »NovaX 350 in a designated RC flying area.

> Stay  away  from  power  lines,  cellphone  towers  and  other  sources  of  potential

interference, and restricted areas.

> Never fly the »NovaX 350 above people.

> Contact a local RC club nearby to find out more about designated and approved flying

areas.

> Correct polarity must be observed while inserting the batteries.

> Remove the battery from the »NovaX 350 after every flight. Remove the batteries from the

transmitter if you do not use it for a longer period of time. Discharged batteries may leak.