CEI Conrad Electronic International Limited RCE-NOVAX350 Manuale Utente
46 | Status Indication Table
37. STATUS INDICATION TABLE
Type
Status
Trigger
Front LED
Rear LED
Buzzer
Flight Mode
Basic (ACC assisted)
Channel 5 : (+100)
Magenta – Solid
Refer to chapter ”GPS”
None
Altitude (Midstick height hold)
Channel 5 : (0)
Green – Solid
Refer to chapter ”GPS”
None
GPS (position hold)
GPS fixed - No signal
Blue – Blinks (fast)
Refer to chapter ”GPS”
None
GPS fixed - Poor signal
Blue – Solid
Refer to chapter ”GPS”
None
Channel 5 : (-100), strong GPS signal
Blue – Solid
Refer to chapter ”GPS”
None
Flight agility
(Bank selection switch)
(Bank selection switch)
Channel 6
No indication
No indication
None
R.T.H. Return-to-Home
Channel 5 triggered via switch or Transmitter (Tx) off
White – Blinks continuously (0.5 Hz)
White – Blinks continuously (0.5 Hz)
Beep beep ... pause 1.5 sec. ... beep beep ... ;
Long beep at every step of the process.
Long beep at every step of the process.
Flight Error
Low battery level 1
Battery <11.4 V
White – Blinks continuously (1 Hz)
White – Blinks continuously (1 Hz)
Continuous single beeps (1 Hz)
Low battery level 2
Battery <10.5 V
White – Blinks continuously (5 Hz)
White – Blinks continuously (5 Hz)
Continuous single beeps (2 Hz)
Fail safe (PPM failed)
Loss of RF signal
White – Blinks continuously (0.5 Hz)
White – Blinks continuously (0.5 Hz)
Beep at each stage of process
Flight Check Error
GPS / compass failed
Start up main board self test
Red – Blinks continuously (1 Hz)
Red – Blinks continuously (1 Hz)
None
Pressure sensor failed
Gyro failed
Power system failed
(ESC/motor)
Permanent system check
Gyro failed
Power system failed
(ESC/motor)
Permanent system check
System error (pilot must land!)
Red – Blinks (fast)
Red – Blinks (fast)
Continuous beeps (5 Hz)
Calibration
Tx
App or button on flight controller
Red – Solid/ Blue – Solid (small LED)
Red – Solid
None
Gyro
App or button on flight controller
Green – Solid/ Blue – Solid (small LED)
Green – Solid
None
Compass
App or button on flight controller
Magenta – Solid/ Blue – Solid (small LED)
Magenta – Solid
None
Tx
Calibration in progress
Red – Solid/ Blue – Blinks (small LED)
Red – Solid
Beep at each stage of the process
Gyro
Calibration in progress
Green – Solid/ Blue – Blinks (small LED)
Green – Solid
Beep at each stage of process
Compass
Calibration in progress
Magenta – Solid/ Blue – Blinks (small LED)
Magenta – Solid
Beep at each stage of process
Factory state
Gyro or compass calibration procedure
Invalid gyro or compass calibration
Cyan – Blinks 1Hz (alternating to rear)
Cyan – Blinks 1Hz (alternating to rear)
None