eResearchTechnology GmbH AM3G01 Manuale Utente
Page 11/42
Peak Flow Meter AM3 - Instructions for Use for Trial xxx
Version 00.03 • Date 04NOV2013
Study specific
2.2 PEF Measurements with the AM
2.2.1 Preparing for the Measurement
Prior to starting the measurement, place the flow sensor into the AM as shown
below. Remove the sealing cap from the flow sensor and put on the mouthpiece.
When inserting the flow sensor into the AM, medical assistants must adhere to the
general hygiene standards valid for hospitals and private practices.
If the flow sensor is inserted into the AM by the subject, the notes on cleaning as
described under the chapter “Cleaning“ must be followed.
below. Remove the sealing cap from the flow sensor and put on the mouthpiece.
When inserting the flow sensor into the AM, medical assistants must adhere to the
general hygiene standards valid for hospitals and private practices.
If the flow sensor is inserted into the AM by the subject, the notes on cleaning as
described under the chapter “Cleaning“ must be followed.
The flow sensor and the mouthpiece are intended for single subject use only.
2.1.5 New Subject Devices
New subject devices are locked, and cannot be used until they are programmed
with a subject number.
with a subject number.
2.1.6 Assigned Subject Devices
After programming the AM with the subject’s unique number, the device is ready
to be used by the subject.
to be used by the subject.
Protocol 000.000
NEW DEVICE
Sealing cap
Flow sensor
Mouthpiece
AM3
Flow sensor