ZOLL Medical I Ltd. UCOR30 Manuale Utente
µCor 3.0 Monitoring System
Instructions for Use
Instructions for Use
Page 7 of 29
• Remove the device (Patch + Sensor) from your body prior to an MRI scan, or any
emergency medical procedure. The µCor 3.0 System is not compatible for use with
MRI machines.
• If you have an implanted pacemaker or defibrillator, do not place the Sensor directly
on top of the implanted device. Consult with your physician about the correct
placement of the device for you.
• Sensor must be turned OFF prior to boarding an airplane. Remove Sensor from Patch
and call ZOLL Cardiac Diagnostics at 1-888-592-3798 for further instructions.
•
Do not wear the Patch for more than 5 days. Replace the Patch every 5 days, or more
frequently when needed. The Patch is designed for a maximum of 5 days use only.
•
No creams of lotions should be applied to the skin immediately prior to the
application of the Patch.
• Do not re-use the Patch. Once the Patch is peeled off or removed, discard
immediately. The Patch is designed for single use. Re-using the Patch may result in
poor adhesion to the body and may affect measurements.
• Remove the device (Patch +Sensor) if any pain or discomfort occurs. If skin irritation,
discomfort, redness, itching or rash persists after the device is removed, a topical,
anti-inflammatory cream may be applied (in consultation with your health care
provider).
• Do not submerge the Sensor in water by swimming or sitting in a tub. The Sensor is
water-resistant, but not waterproof. Wearing the Sensor while showering is okay.
• Keep the Charger away from water.
•
The power adapter connector should not be touched or manipulated when the Power
Adapter is connected to power outlet.
• Do not change, modify, or disassemble any parts or components of the µCor 3.0
System. The system contains no user-serviceable components. Any changes,
modification, or servicing of the µCor 3.0 System will only be performed by ZOLL.
• Connect the Charger to the AC adapter that is provided with the system in the original
packaging. Using any other AC adapter may damage the Charger and may have
electric hazards.
• Place the Sensor in the Charger when not in use.
• When using the µCor 3.0 System, use only cables and accessories provided by ZOLL.
Using non-approved cables and accessories may affect the EMC performance