Cyrus Audio Ltd. JG10 Manuale Utente
Cyrus 6
DAC
, Cyrus 8
DAC
, Cyrus 8
Qx DAC
User Instructions
7
Connecting loudspeakers
Fit plugs to the loudspeaker cables making sure to line up +
and - at each end. Most cables have polarity indicators and
may also be marked for directionality. The + and - terminals
must be connected to the corresponding + and - terminals
of the loudspeakers.
Ensure that the connections are secure, then connect the
Ensure that the connections are secure, then connect the
left and right loudspeakers to the rear panel sockets 1@ and
a
.
NOTE: The dual output sockets are provided for convenient
connection of bi-wiring speaker cables as shown.
Using the Zone 2 output of your amplifier
your product includes a Zone 2 pre-amp output that can be
used by a system in a second room. you can then extend the
sound from the sources in your main system to a second
zone. To use the Zone 2 output you will need a set of long
interconnects and an amplifier with loudspeakers in the
second zone that has its own volume control. Typically the
second zone system would be the auxiliary input of an MP3
player dock or could even be another integrated amplifier
with full size separate loudspeakers.
Setting up Zone 2 with powered speakers
To set up Zone 2, connect the long phono cables to the Zone
Setting up Zone 2 with powered speakers
To set up Zone 2, connect the long phono cables to the Zone
2 output e and route them to the line inputs of the powered
speakers in Zone 2.
Setting up Zone 2 with a second amplifier
To set up Zone 2 with a separate amplifier, connect the long
Setting up Zone 2 with a second amplifier
To set up Zone 2 with a separate amplifier, connect the long
phono cables to the Zone 2 output e and route them to one
of the line inputs of the amplifier in Zone 2. Connect the
Zone 2 speakers to the Zone 2 amplifier.
NOTE: Amplifiers for Zone 2 use must include a volume
NOTE: Amplifiers for Zone 2 use must include a volume
control.
Connecting a Tape/Disc recorder for recording
When not in use for a Zone 2 system, the dual-purpose
Connecting a Tape/Disc recorder for recording
When not in use for a Zone 2 system, the dual-purpose
output Zone 2/Tape may be used to connect a tape recorder
for recording purposes. To set up a tape recording loop,
connect a phono cable from the ‘Input’ or ‘Record’ sockets
of the tape deck to the Zone 2 Output e sockets.
NOTE: This section assumes that the ‘Play’ or ‘Line Out’
NOTE: This section assumes that the ‘Play’ or ‘Line Out’
sockets of the tape/disc recorder have already been
connected to Input 6 for playback purposes.
+
+
-
-
-
+
-
+
Right
bass
Left
bass
Right
treble
Left
treble
Amplifier
Connecting a bi-wired speaker system