Hui Zhou Gaoshengda Technology Co. LTD WC0HR2601 Manuale Utente
FCC Information (additional)
OEM integration instructions:
This device is intended only for OEM integrators under the following conditions:
The transmitter module may not be co-located with any other transmitter or antenna. The
module shall be only used with the integral antenna(s) that has been originally tested and
certified with this module. A distance of 20 cm shall be maintained between the antenna
and users. As long as the conditions above are met, further transmitter test will not be
required.
However, the OEM integrator is still responsible for testing their end-product for any
additional compliance requirements required with this module installed (for example, digital
device emissions, PC peripheral requirements, etc.).
The transmitter module may not be co-located with any other transmitter or antenna. The
module shall be only used with the integral antenna(s) that has been originally tested and
certified with this module. A distance of 20 cm shall be maintained between the antenna
and users. As long as the conditions above are met, further transmitter test will not be
required.
However, the OEM integrator is still responsible for testing their end-product for any
additional compliance requirements required with this module installed (for example, digital
device emissions, PC peripheral requirements, etc.).
Validity of using the module certification:
In the event that these conditions cannot be met (for example certain laptop configurations
or co-location with another transmitter), then the FCC authorization for this module in
combination with the host equipment is no longer considered valid and the FCC ID of the
module cannot be used on the final product. In these circumstances, the OEM integrator
will be responsible for re-evaluating the end product (including the transmitter) and
obtaining a separate FCC authorization.
In the event that these conditions cannot be met (for example certain laptop configurations
or co-location with another transmitter), then the FCC authorization for this module in
combination with the host equipment is no longer considered valid and the FCC ID of the
module cannot be used on the final product. In these circumstances, the OEM integrator
will be responsible for re-evaluating the end product (including the transmitter) and
obtaining a separate FCC authorization.
End product labeling:
The final end product must be labeled in a visible area with the following:
“Contains Transmitter Module FCC ID: 2AC23-WC0HR2601”.
“Contains Transmitter Module FCC ID: 2AC23-WC0HR2601”.
Information that must be placed in the end user manual of the end-product:
The OEM integrator has to be aware not to provide information to the end user regarding
how to install or remove this RF module in the user's manual of the end product which
integrates this module. The end user manual shall include all required regulatory
information/warning as show in this manual.
how to install or remove this RF module in the user's manual of the end product which
integrates this module. The end user manual shall include all required regulatory
information/warning as show in this manual.
FCC Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate this equipment.
responsible for compliance could void the user’s authority to operate this equipment.
IEEE 802.11b or 802.11g operation of this product in the USA is firmware-limited to
channels 1 through 11.
channels 1 through 11.
RF Exposure: A distance of 20 cm shall be maintained between the antenna and users,
and the transmitter may not be co-located with any other transmitter or antenna.
and the transmitter may not be co-located with any other transmitter or antenna.
Approved Antennas:
WiFi Antenna: PIFA Antenna as certified for FCC:
2412~2462 Antenna Peak Gain: 3 dBi
5150~5250 Antenna Peak Gain: 3 dBi
5750~5850 Antenna Peak Gain: 3 dBi
5150~5250 Antenna Peak Gain: 3 dBi
5750~5850 Antenna Peak Gain: 3 dBi