Parker Hannifin Corporation SNG2 Manuale Utente

LED Status

FCC Disclaimer

 then 

 then 

 – Sensor 

starting up (If this repeats over and over, 

the battery is too low to start up the radio)

 (single brief flash) – Sensor 

advertising/broadcasting

 (solid while button held), 

 

(flash), 

 (flash) – Powering off

LED Status

 (single brief flash) – Sensor 

measurement – Sensor reading between 

0% and 25% of span

 (single brief flash) – Sensor 

measurement – Sensor reading between 

25% and 50% of span

 (single brief flash) – Sensor 

measurement – Sensor reading between 

50% and 75% of span

 (single brief flash) – Sensor 

measurement – Sensor reading between 

75% and 100% of span

(Connected Mode)

www.parker.com/conditionmonitoring   763.544.7781

TM

Sensors

Support

Parker Hannifin Corporation

Quick Coupling Division

Minneapolis, MN

www.parker.com/conditionmonitoring

www.parker.com/conditionmonitoring   763.544.7781

ID: 2ACDM-SNG2

IC: 11983A-SNG2

This equipment has been tested and found to comply with the limits 

for a Class B digital device, pursuant to Part 15 of the FCC Rules. 

These limits are designed to provide reasonable protection against 

harmful interference in a residential installation. This equipment 

generates, uses and can radiate radio frequency energy and, if not 

installed and used in accordance with the instructions, may cause 

harmful interference to radio communications. However, there is no 

guarantee that interference will not occur in a particular installation. 

This device complies with Part 15 of the FCC Rules. Operation is 

subject to the following two conditions: (1) this device may cause 

harmful interference, and (2) this device must accept any interference 

received, including interference that may cause undesired operation.
If this equipment does cause harmful interference to radio or 

television reception, which can be determined by turning the 

equipment off and on, the user is encouraged to try to correct the 

interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from  

  that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications not expressly approved by the party 

responsible for compliance could void the user’s authority to 

operate the equipment.
This equipment complies with FCC radiation exposure limits 

set forth for an uncontrolled environment. End user must follow 

the specific operating instructions for satisfying RF exposure 

compliance. This transmitter must not be co-located or operating 

in conjunction with any other antenna or transmitter. The portable 

device is designed to meet the requirements for exposure to radio 

waves established by the Federal Communications Commission 

(USA).
This device complies with Industry Canada license-exempt RSS 

standard(s). Operation is subject to the following two conditions: 

(1)

 this device may not cause interference, and 

(2)

 this device must 

accept any interference, including interference that may cause 

undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada 

applicables aux appareils radio exempts de licence. L’exploitation 

est autorisée aux deux conditions suivantes : 

(1)

 l’appareil ne 

doit pas produire de brouillage, et 

(2)

 l’utilisateur de l’appareil 

doit accepter tout brouillage radioélectrique subi, même si le 

brouillage est susceptible d’en compromettre le fonctionnement.