CognitiveTPG LLC 0481402 Manuale Utente

(amber) 

(5 blinks) 

(solid green)

5.3 Printer Initialization

Printer initialization is used to clear DRAM and restore printer settings to defaults.

Printer initialization is activated by the following procedures.

1. Turn off the power switch.

2. Hold on the FEED button( ) then turn on the power switch.

3. Release the FEED button( ) when the indicator becomes

and

blinking. (Any green will do during the 5 blinks).

 The LEDs will be changed as following:

Printer configuration will be restored to defaults as below after initialization.

Parameter

Default setting

Speed

50.8 mm/sec (2 ips)

Density

Media Width

2.83” (72 mm)

Media Height

4” (101.5 mm)

Sensor Type

Black mark sensor (As paper end sensor)

Black Mark Setting

As paper end sensor

Print Direction

Reference Point

0,0 (upper left corner)

Offset

Serial Port Settings

9600 bps, none parity, 8 data bits, 1 stop bit

Code Page

850

Country Code

001

Clear Flash Memory

IP Address

DHCP