VP9 Vietnam. JSC VP9B2 Manuale Utente

, then, following the prompt on the

screen, select your wireless network and input your password (click on the input
area, a virtual keyboard will appear). Finally, click on “Connect” to link to internet.
(See below figures)

Click and move the RC, you will see a cursor on the screen, click on the “ ”,

you will enter into all apps, then click "setting"

7) Press “Return” ( ) key on the remote controller to get back the previous page.

2) The default output of the Box is HDMI and AV OUT, so you only need to adjust
the input mode of your TV set, don’t worry about the output setting of the Box.

1) The VP9 TV Box will auto-detect the TV’s screen size, and auto-fit the display
area. In case you find the display area does not fit your television screen, please
click on “ ”

“Settings”

“Screen”

“Screen scale”, then, drag the work bar

to adjust the display area. (See below figures)

4. Tips:

3) For better remote control result, please make sure the Box front panel face
forward, not blocked by any surface. And the best angels to use the remote
controller is 90 degrees, see below figure.

Best remote control angle

5. Remote controller instructions:

Volume down

Volume up

Power

Zoom

Return

Press to go the

game folder

Press to go
the film

Home page

Quick Start Guide

Tips: Press and hold the “Zoom” ( ) key, rotate left to zoom out, and rotate right
to zoom in. Note, zoom functions are only available under certain websites or games,
not everywhere.

FCC STATEMENT

1.This device complies with Part 15 or the FCC Rules. Operation is subject to the following two conditions:

(1)This device may not cause harmful interference, and

(2)This device must accept any interference received, including interference that may cause undesired operation.

2.Changer or modifications not expressly approved by the party responsible for compliance could void the

user's authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B

digital, pursuant to Part 15 or the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may casue harmful interference to radio

communications, However, there is no guarantee that interference will not occur in a
particular installation. If the equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user

is encouraged to try to correct the interference by one or more of the following measures:
--- Reorient or relocate the receiving antenna.
--- Increase the separation between the equipment and receiver.
--- Connect the equipment into an outlet on a circuit different

from that to which the receiver is connected.

--- Consult the dealer or an experienced radio/ TV technician for help.

FCC Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. In order to avoid the possibility of exceeding the
FCC radio frequency exposure limits, Human proximity to the antenna shall

not be less than 20cm (8 inches) during normal operation.