EM Microelectronic-Marin SA EMBC01 Manuale Utente
This document is the property of EM MICROELECTRONIC-MARIN SA upon the condition that all rights originating in the information, whether patented or not, will be
respected.
EMBC01 User Manual v0.1 September-2014
DRAFT A
PRELIMINARY
3. BATTERY REPLACEMENT INSTRUCTIONS
The EMBC01 is powered by a single CR2032 battery. When the beacon stops functioning the battery will
need to be replaced. The step-by-step sequence to replace the expired battery with a fresh one is given in
the steps below.
Step 1: Open the beacon housing. Grasp the unit by the edges and pry the top off, exposing the circuit
board, battery and battery holder.
need to be replaced. The step-by-step sequence to replace the expired battery with a fresh one is given in
the steps below.
Step 1: Open the beacon housing. Grasp the unit by the edges and pry the top off, exposing the circuit
board, battery and battery holder.
Step 2: Remove the battery. Slide the battery out from the holder.
Step 3: Replace the battery with a new Renata CR2032 Lithium 3V battery. Reverse the sequence in step2
above. Care must be taken to insert with a slight downward pressure so as not to damage the metal dome
switch that is located under the battery. On initial battery insertion both the red and green LEDs will flash
momentarily to indicate the start-up diagnostics have been completed successfully.
Step 4: Reassemble the case making sure the top is securely positioned around the bottom housing.