EM Microelectronic-Marin SA EMBE01 Manuale Utente
This document is the property of EM MICROELECTRONIC-MARIN SA upon the condition that all rights originating in the information, whether patented or not, will be
respected.
respected.
EMBE01 User Manual v0.1 January-2015
DRAFT A
PRELIMINARY
3. BATTERY REPLACEMENT INSTRUCTIONS
The EMBE01 is powered by four AA batteries. When the beacon stops functioning the battery will need to
be replaced. The step-by-step sequence to replace the expired battery with a fresh one is given in the steps
below.
Step 1: Remove the EMBE01 from the wall mount as shown in Figure 1. Gently lift the tab using a small pry
tool to unclip the unit form the wall mount. If installed, the security screw must be removed prior to lifting the
tab. To remove from the mount, tilt the device forward then lift out of the wall mount as shown in Figure 2.
be replaced. The step-by-step sequence to replace the expired battery with a fresh one is given in the steps
below.
Step 1: Remove the EMBE01 from the wall mount as shown in Figure 1. Gently lift the tab using a small pry
tool to unclip the unit form the wall mount. If installed, the security screw must be removed prior to lifting the
tab. To remove from the mount, tilt the device forward then lift out of the wall mount as shown in Figure 2.
Figure 1: Lift wall mount tab using small pry tool
Figure 2: Tilt device forward then lift to remove from mount
Step 2: Open the beacon housing. Remove the 4 screws in the order indicated in Figure 3.
Figure 3: Remove screws in indicated direction and lift off cover
1
2
3
4