3D Systems Corporation MERCURY Manuale Utente
3D Systems, Inc.
1
p/n 77-D005 Rev_A
NOTE: You can find material-specific information about breaking out and cleaning parts in your Material
Guide.
Before breakout, you must:
•
Cool down the print cake then remove the part transfer cylinder from the print chamber
—or vice-versa.
•
Roll the part transfer cart to the ProX
®
MQC Single Use System and unload the print cylinder onto the
breakout area.
•
Remove the print cylinder.
•
Remove the surrounding powder from the outline of the parts with a spatula and brush. Ensure the sifter is
running, then brush unsintered print cake powder into the sifter.
running, then brush unsintered print cake powder into the sifter.
•
When you can easily grasp a part, carefully lift it. Gently brush off the parts and place them on the breakout
area of the ProX
area of the ProX
®
MQC Single Use System.
Part Finishing After Breakout
NOTE: Consult your Material Guide for full details on part finishing.
After breakout, remove and dispose of any remaining print cake material from holes and crevices .
Your SLS system ships with a basic set of rough and fine part cleaning tools. You may find it useful to supplement these
with other fine tools, picks, and brushes, such as those used for dental and jewelry work.
with other fine tools, picks, and brushes, such as those used for dental and jewelry work.
3D Systems recommends you also purchase a glass bead blaster (pneumatic blast cabinet). A bead blaster makes fine
cleaning much easier and faster . See your
cleaning much easier and faster . See your
Facility Guide
for specifications.