Ulterius Technologies LLC FDN40 Manuale Utente
CHAPTER 5: VLAN
Configuration User Manual
121
© Ulterius Technologies, LLC 2016. Confidential & Proprietary.
BPDU tunneling on the port cannot be set; if Dot1q tunnel status is
disabled.
disabled.
Leave Timer must be two times greater than Join Timer, and Leaveall
Timer must be greater than Leave Timer.
Timer must be greater than Leave Timer.
5.4 Default Configurations
Table 5-1: Default Configurations
Feature
Default Setting
VLAN Module status
Enable
Default VLAN Id configured in the switch
1
Mac based VLAN Classification
Disabled
Protocol-VLAN based classification
Enabled
System and port level GVRP and GMRP
Module status
Module status
Enabled
Mac address table aging time
300 seconds
Acceptable frame types
All (Accepts untagged frames or priority-tagged frames
or tagged frames received on the port)
or tagged frames received on the port)
Ingress filtering
Disabled
Switch port priority
0
Switch port mode
Hybrid
GARP Timers
Join: 20 seconds
Leave: 60 seconds
Leave all: 1000 seconds
Leave: 60 seconds
Leave all: 1000 seconds
Max traffic classes
Maximum number of traffic classes supported on a port
is 8
is 8
Tunneling
Disabled
In case of Provider Bridges, the default configurations and configuration guidelines
are provided in the relevant subsection itself.
are provided in the relevant subsection itself.
5.5 VLAN Configurations
5.5.1
Configuring Static VLAN
Static VLAN entries can be configured with the required number of member
ports, untagged ports and forbidden ports. The following configuration deals
with the creation of member ports.
ports, untagged ports and forbidden ports. The following configuration deals
with the creation of member ports.
5.5.1.1
CLI Configuration
1. Execute the following commands to configure Static VLAN entry in the
switch.
Enter the Global Configuration Mode.
UltOs# configure terminal
Enter the VLAN Configuration Mode (for VLAN 2).