Ulterius Technologies LLC FDN40 Manuale Utente
CHAPTER 4: RIP
Configuration User Manual
88
© Ulterius Technologies, LLC 2016. Confidential & Proprietary.
4.5.8.2
WEB Configuration
RIP Redistribution can be configured through WEB interface using the RRD
RIP Configuration screen (Navigation - Layer3 Management > RRD > RIP)
RIP Configuration screen (Navigation - Layer3 Management > RRD > RIP)
Screen 4-6: RRD RIP Configuration
4.5.8.3
Sample Configuration to Test Redistribution
Refer the Section 4.3 for configuration guidelines and Figure 4-1 for the
Setup. The prerequisite configuration needs to be done in the switches
(FDN40-1 and FDN40-2) before configuring RIP.
1. Execute the following commands in the switch FDN40-1 to test
Setup. The prerequisite configuration needs to be done in the switches
(FDN40-1 and FDN40-2) before configuring RIP.
1. Execute the following commands in the switch FDN40-1 to test
redistribution.
Enter the Global Configuration mode.
UltOs# configure terminal
Enable RIP globally in the switch FDN40-1.
UltOs(config)# router rip
Enable RIP over the interface vlan 1 (IP address 10.0.0.1/16)
UltOs(config-router)# network 10.0.0.1
Configure redistribution of static routes in the RIP domain
UltOs(config-router)# redistribute static
UltOs(config-router)# exit
Add static routes
UltOs(config)# ip route 50.0.0.0 255.0.0.0 vlan 2