Acegame S.A ZENFLOW Manuale Utente

 

 

5

Specific Absorption Rate (SAR) information SAR tests are conducted using 

standard operating positions accepted by the FCC with the phone transmitting at 

its highest certified power level in all tested frequency bands 

Before a new model phone is a available for sale to the public, it must be tested 

and certified to the FCC that it does not exceed the exposure limit established 

by the FCC, Tests for each phone are performed in positions and locations (e.g. 

at the ear and worn on the body)as required by the FCC. 

For body worn operation, this mobile phone has been tested and meets the FCC 

RF exposure guidelines when used with an accessory designated for this product 

or when used with an accessory that contains no metal and that positions the 

handset a minimum of 1.0 cm from the body.   

 

This device complies with part 15 of the FCC Rules. Operation is subject to the 

following two conditions:

(1) This device may not cause harmful interference, and

(2) 7his device must accept any interference received, including interference  

      that may cause undesired operation.

Any Changes or modifications not expressly approved by the party responsible 

for compliance could void the user’s authority to operate the equipment.     

   

Note: 

This equipment has been tested and found to comply with the limits for a 

Class B digital device, pursuant to part 15 of the FCC Rules. These limits are 

designed to provide reasonable protection against harmful interference in a 

residential installation. This equipment generates uses and can radiate radio 

frequency energy and, if not installed and used in accordance with the 

instructions, may cause harmful interference to radio communications. However, 

there is no guarantee that interference will not occur in a particular installation. 

If this equipment does cause harmful interference to radio or television 

reception, which can be determined by turning the equipment off and on, the 

user is encouraged to try to correct the interference by one or more of the 

following measures:       

--Reorient or relocate the receiving antenna.   

--Increase the separation between the equipment and receiver.     

--Connect the equipment into an outlet on a circuit different from that to which