SALUS North America Inc. SS909ZB Manuale Utente
Version 2
Installation/Quick Start Guide: Temperature Sensor (SS909ZB)
Visit www.salusinc.com for the User Manual
In the Box
Tools Needed
Note:
Additional equipment may be required
due to building construction or materials,
or other radio interference that may
reduce the radio range.
or other radio interference that may
reduce the radio range.
Sensor w/ Wall Plate and Battery
(1x CR2, 3V Lithium)
Stand
Mounting Kit
Installation/
Quick-start Guide
#1 Phillips Screwdriver
P
AIRING
I
NSTRUCTIONS
•
Follow your system’s instructions to prepare to add devices to the
system.
•
Remove the face plate from the Sensor and pull the battery tab to
start the pairing process.
•
When the Sensor is detected and added to the system, proceed to the
Sensor installation.
W
ALL
I
NSTALLATION
I
NSTRUCTION
•
Identify the location for the Wall Plate, orienting the metal
plate of the Sensor Wall Plate at the bottom if installing
vertically. Horizontal installation is also supported. For best
readings, the Sensor should be in an open area, away from
the direct air flow of HVAC vents.
•
Position the Wall Plate at the desired location and screw
into position using the screws provided.
•
Place the Sensor over the latch and slide into position on the wall plate.
D
ESK
/C
OUNTERTOP
P
LACEMENT
•
For desk or countertop placement, simply place the Sensor over the
latch in the Stand and slide down into position.
LED
I
NDICATIONS
Solid at power up:
Initializing, checking for Factory Reset
3 flashes then pause:
Searching for network to join
R
EPLACING THE
B
ATTERY
(Use only Duracell DL-CR2, Rayovac RL-CR2, Energizer EL1CR2, or GP Batteries GPCR2 batteries)
•
Grasp the top of the Sensor face plate and lift it from the Sensor body.
•
Press a finger on the positive end of the battery and lift to remove the
battery from the Sensor.
•
Insert a new battery into the Sensor, observing the proper polarity.
•
Position the Sensor face plate over the Sensor body and snap the face
plate onto the body.
F
ACTORY
R
ESETTING THE
S
ENSOR
•
Remove the Sensor face plate from the Sensor body.
•
Remove the battery.
•
Press and hold the side button while re-inserting the battery.
•
Release the side button when the LED lights on the front of the Sensor.
The Sensor is reset to factory defaults and will respond to pairing
requests.
•
After pairing, position the Sensor over the Mounting Plate and snap the
Sensor onto the Mounting Plate.