Doodle Labs Pte Ltd NM-2450-2F Manuale Utente

Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to
operate the equipment. 
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules.  These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment   generates   uses   and   can   radiate   radio   frequency   energy   and,   if   not   installed   and   used   in   accordance   with   the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:

-- Reorient or relocate the receiving antenna. 
-- Increase the separation between the equipment and receiver. 

-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 

-- Consult the dealer or an experienced radio/TV technician for help

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions (1)this device may not 
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause 
undesired operation

150 Kampong Ampat

2 Mattawang Drive

KA Center, Suite 05-03

Somerset, NJ 08873

Singapore 368324

Tel: +1 862 345 6781

Tel:  +65 6253 0100

Fax: +65 6353 5564

 

 

 

 

 

 

The antenna(s) used for this transmitter must be installed to provide a

separation distance of at least 20 cm from all persons and must not be

collocated or operating in conjunction with any other antenna or transmitter,

except in accordance with FCC multi-transmitter product procedures.

Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an

uncontrolled environment.

This transmitter must not be co-located or operating in conjunction with any other

antenna or transmitter.

The availability of some specific channels and/or operational frequency bands

are country dependent and are firmware programmed at the factory to match

the intended destination.

The firmware setting is not accessible by the end user.

The final end product must be labelled in a visible area with the following:

“Contains Transmitter Module 2AG87NM-2450-2F”

In the event that these conditions can not be met (for example certain laptop configurations

or co-location with another transmitter), then the FCC authorization is no longer considered

valid and the FCC ID can not be used on the final product. In these circumstances, the OEM

integrator will be responsible for re-evaluating the end product (including the transmitter) and

obtaining a separate FCC authorization

et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible

Le présent appareil est conforme aux CNR d'Industrie Canada applicable aux appareils radio exempts de licence.

The term "IC: " before the certification/registration number only signifies that the Industry Canada technical specifications were met. 

(1) This device may not cause interference; and 

This device complies with Industry Canada's licence-exempt RSSs. Operation is subject to the following two conditions: 

(2) This device must accept any interference, including interference that may cause undesired operation of the device. 

This product meets the applicable Industry Canada technical specifications.

L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage,

d'en compromettre le fonctionnement

The modular can be installed or integrated in mobile or fix devices only. 

This modular cannot be installed in any portable device, for example,

USB dongle like transmitters is forbidden.

The module could be only used as a system and integrated as a system and compliance with

the Section 15.204(b) rule part.