Domino UK Limited EPT012462 Manuale Utente

Electronic Technical Report

Revision: 3.0

Ax Series – QMM User Manual

Document Number: Doc-0009875

Page 6 of 17

No part of this publication may be reproduced, stored on a retrieval system, or transmitted in any form, or by any means, electronic,

mechanical, photocopying, recording or otherwise, without the prior permission of Domino Printing Sciences Ltd.

Installation

The QMM sub system is installed in four steps. Ensure the machine is powered off and the
power cord is removed:

 Place the QMM-LSM module into the printer on the brackets provided. The lugs on the

QMM-LSM module should locate into the holes within each bracket. Secure the
module with two M4 nuts (Domino part number 1-0140414).

 Locate the QMM-RF ID bracket onto the ink block of the printer. There are two

location bumps on the back of the bracket which line up the bracket on the ink block.
Secure the bracket in place with two M3 x 10mm torx screws (Domino part number
EPT020362).

 Plug in the USB cable into the ink interface printed circuit board (PCB) USB socket on

top left of the back wall of the ink enclosure.