The Watt Stopper Inc. d/b/a Qmotion QMRS-908 Manuale Utente
7
Z-Wave Operating Notes
TUG COMMAND MODES
1. Tug hem bar 2 times within 800ms to enter command mode
2. Shade responds to signal command mode entry (Jog**)
3. Shade will time-out after 5 seconds of inactivity and perform command failure response (Jog**)
4. Once Shade enters command mode, perform additional Taps/Tugs to send commands
A. Add/Remove shade —1 additional
B. Calibrate — 2 additional
C. Battery Change Mode — 4 additional
D. Z-Wave Reset — 6 additional
E. Factory Reset — 8 additional
** Shade will perform command after a 5 second time-out from last Tug
OPEN/CLOSE SHADE FULLY WITH CONTROLLER
1. From Z-Wave controller panel select “multi-level switch device”
2. Select specific shade from list
3. Select On/Off to Open/Close respectively
OPEN/CLOSE SHADE FULLY MANUALLY
1. Short Tug once to open shade fully (no manual close)
SHADE INTERMEDIATE POSITIONS
1. From Z-Wave controller panel select “multi-level switch device”
2. Select specific shade from list
3. Use dimming or fixed intermediate position buttons
Z-WAVE RESET
1. Initiate Tug command mode, verify shade performs command mode entry action
2. Tug additional 6 times
3. Shade should perform command completion or failure action
4. After successful RESET, all shade calibration setting and Z-Wave setting are cleared, and the shade goes into low power
OPEN/CLOSE SHADE FULLY WITH CONTROLLER
1. From Z-Wave controller panel select “multi-level switch device”
2. Select specific shade from list
3. Select On/Off to Open/Close respectively
OPEN/CLOSE SHADE FULLY MANUALLY
1. Short Tug once to open shade fully (no manual close)
SHADE INTERMEDIATE POSITIONS
1. From Z-Wave controller panel select “multi-level switch device”
2. Select specific shade from list
3. Use dimming or fixed intermediate position buttons
Z-WAVE RESET
1. Initiate Tug command mode, verify shade performs command mode entry action
2. Tug additional 6 times
3. Shade should perform command completion or failure action
4. After successful RESET, all shade calibration setting and Z-Wave setting are cleared, and the shade goes into low power
__
mode.
Z-WAVE MODULE FIRMWARE UPDATE OVER-THE-AIR (OTA)
1. Supported on Z-Wave Plus controller for Z-Wave module firmware only