Kinestral Technologies UC100 Manuale Utente
HUG-TS 181010 v0.5
Tint Selector User Guide
INTRODUCTION
Halio Tint Selector lets users wirelessly adjust the tint levels
of Halio Smart Glass. It can be easily wall-mounted or placed
on a table top and can control a single window or large group
of windows. Tint Selector guides the user to set one of nine
tailored tint levels – from clear to completely tinted.
of Halio Smart Glass. It can be easily wall-mounted or placed
on a table top and can control a single window or large group
of windows. Tint Selector guides the user to set one of nine
tailored tint levels – from clear to completely tinted.
USING TINT SELECTOR
Use Tint Selector to control Halio Smart Glass tinting much
like you would use a simple dimmer light switch. Pressing the
top or bottom keypad button adjusts the target tint level to
one of 9 levels.
like you would use a simple dimmer light switch. Pressing the
top or bottom keypad button adjusts the target tint level to
one of 9 levels.
A. Press top of the Tint Selector one or more times to
reduce the tinting level and clear the glass.
B. Press the bottom one or more times to increase
tinting and darken the glass.
One of the LEDs on the gradient scale blink three times to
confirm the new tint level target.
confirm the new tint level target.
Note: Whenever you use Halio Tint Selector, you temporarily
override the current pre-set program. Pre-set programming
will resume with the onset of the next scheduled event.
override the current pre-set program. Pre-set programming
will resume with the onset of the next scheduled event.
TROUBLESHOOTING
If Halio Tint Selector becomes unresponsive with no LED
activity, you most likely need to change the batteries much
like you periodically change the batteries in a TV remote
control.
Change Batteries
activity, you most likely need to change the batteries much
like you periodically change the batteries in a TV remote
control.
Change Batteries
To change the batteries:
1. Slide the Tint Selector up to remove it from the back
mounting plate.
2. Slide out the two CR2032 batteries from the battery clips
using your fingers to slide from the top down.
3. Slide two fresh batteries into the clips pushing from the
bottom up.
If LEDs blink but commands appear unresponsive, it may be
useful to reboot the device using the reset button.
useful to reboot the device using the reset button.
Device Reboot
To reboot the Tint Selector:
1. Slide the Tint Selector up to remove it from the back
mounting plate.
2. Click the Reset button using a pen or paperclip.
3. LEDs will blink as the device restarts and rejoins the
3. LEDs will blink as the device restarts and rejoins the
wireless mesh network.