Apprion Inc. APP2X001 Manuale Utente
Chapter 5
– Cabling the IONizer
Page 16
Apprion Proprietary & Confidential
Attach the earth ground wire (not supplied) to the ring terminal attached to the IONizer’s grounding
stud. Ensure that the ring tongue terminal is seated against the IONizer’s outer case.
stud. Ensure that the ring tongue terminal is seated against the IONizer’s outer case.
IONizer 4300
These devices are designed for use in ATEX ZONE1, Category 2 hazardous locations as defined in the
ATEX directive. All wiring (and conduit connections) to the unit must conform to the recommended
practices of affected local and county electrical codes.
ATEX directive. All wiring (and conduit connections) to the unit must conform to the recommended
practices of affected local and county electrical codes.
Two Cat 5 cables protrude from the conduit opening at the bottom of the unit (cable is hardwired inside
the IONizer in 24-inch length). Cable ends are marked with a “W” for WAN and “L” for LAN for ease of
identification. Two other wires are available for 24V. The two Ethernet cables are terminated with an
RJ45 connector. The following diagram shows the required conduit and cable connections:
the IONizer in 24-inch length). Cable ends are marked with a “W” for WAN and “L” for LAN for ease of
identification. Two other wires are available for 24V. The two Ethernet cables are terminated with an
RJ45 connector. The following diagram shows the required conduit and cable connections: