Mitsumi FA404 series Internal USB2.0 Flash Media + Floppy Drive Beige FA404M?BEIGE Dépliant
Codici prodotto
FA404M?BEIGE
MITSUMI Multi-Drive 7FDD FA404M
Internal FDD & Flash Memory Card RW
Quick installation manual
1. System Requirements
Hardware
z
PC-AT compatible computer with an internal USB connection to the motherboard.
*
This drive supports USB2.0 High-speed (480Mbps) but operates at USB1.1 Full-speed (12Mbps) when connected to a USB
1.1 port.
1.1 port.
z
An available 3.5 inch drive bay
OS
z
Windows 98SE / 2000 / ME / XP and Mac OS 8.6 or higher
*
For Windows 98SE and Windows 2000 before service pack 2, you must install the USB device driver before connecting the
drive to your computer. (please refer to Sub-Section 2).
drive to your computer. (please refer to Sub-Section 2).
*
Special drive icons for Windows ME, Windows 2000 SP 3 and Windows XP can be shown if you install the USB device
driver.
driver.
2. Installation of device driver
!
It is necessary to install the device driver before connecting the drive.
1) Download the device driver from www.mitsumi.com.
2) Execute “Setup.exe”.
3) Please follow the installation Wizard’s directions.
4) When the installation is finished, a dialog box to promote restart is shown. Check [No, restart
2) Execute “Setup.exe”.
3) Please follow the installation Wizard’s directions.
4) When the installation is finished, a dialog box to promote restart is shown. Check [No, restart
computer later] and click [completion] button. Shut down and power off the computer, and mount
the drive (please refer to Sub-Section 3).
the drive (please refer to Sub-Section 3).
3. Mounting the drive
!
The drive may be connected after turning off the computer completely.
!
Internal USB connection interface specifications vary by motherboard manufacturer.
Please have the motherboard operation manual open for reference before connecting.
Please have the motherboard operation manual open for reference before connecting.
1) Mount the drive to an available 3.5 inches drive bay.
*
Use 6-32 x 3/8” screws to affix the 3.5 inch floppy disk to the drive bay.
*
Screws are not included. A minimum of four screws may be needed.
1
2
34
33
33
+5VDC
GND
GND
NC
2) Connect the FDD interface connector from the rear of the drive to the connector on the motherboard
with the FDD interface cable. (Please make sure to check the pin assignment in Figure 2, and
connect the interface properly)
3) Connect the FDD power cable from the computer power source to the FDD power connection at the
rear of the drive.
4) Connect the USB interface cable from the rear of the drive to the USB internal connection on the
motherboard.
!
The connection above is an example of a typical pin assignment. Internal motherboard
USB connection Pin assignments vary by manufacturer. Please refer to your
motherboard’s operation manual to insure the proper connection of the USB interface.
USB connection Pin assignments vary by manufacturer. Please refer to your
motherboard’s operation manual to insure the proper connection of the USB interface.
5) Turn computer on and boot system. The drive will be recognized automatically. Please make sure
that (1) 3.5 inches FD and (2) Removable disk icons are shown in the “My Computer” window.
*
Recognition of the floppy disk drive depends on the setting of the motherboard BIOS.
Removable disk #0
Removable disk #1
3.5" FD
Figure 1 FA404M rear view
Figure 2 A FA404M FDD connector detailed drawing
Figure 3 USB connector pin assignment for a typical internal connection, and a connection example
Figure 4 Device names recognized for each slot