Finisar FTLF1424P2BCL Manuale Utente
FTLF1424P2xCL and FTLF1424P2xCV SFP Product Specification – December 2006
F i n i s a r
© Finisar Corporation December 18, 2006 Rev A Page 5
11. Measured with conformance signals defined in FC-PI-2 Rev. 10.0 specifications. Represents
sensitivity based on OMA spec, as corrected to incoming Extinction Ratio of 13 dB (for example, at
5.75dB incoming extinction ratio, an OMA of 0.029 mW corresponds to -16 dBm sensitivity).
Measured with PRBS 2
5.75dB incoming extinction ratio, an OMA of 0.029 mW corresponds to -16 dBm sensitivity).
Measured with PRBS 2
7
-1 at 10
-12
BER .
12. Rate Selectable version in low bandwidth mode with minimum 9dB extinction ratio.
13. Rate Selectable version in low bandwidth mode.
14. Rate Selectable version in high bandwidth mode.
13. Rate Selectable version in low bandwidth mode.
14. Rate Selectable version in high bandwidth mode.
V.
General Specifications
Parameter Symbol
Min
Typ
Max
Units
Ref.
Data Rate
BR
1062
4250
Mb/sec 1
Bit Error Rate
BER
10
-12
2
Max. Supported Link Length on
9/125
9/125
μm SMF @ 4X Fibre Channel
L
MAX1
30
km
3
Max. Supported Link Length on
9/125
9/125
μm SMF @ 1X and 2X Fibre
Channel
L
MAX2
30 km
3
Max. Supported Link Length on
9/125
9/125
μm SMF @ Gigabit Ethernet
L
MAX3
30 km
3
Notes:
1. Gigabit Ethernet and 1x/2x/4x Fibre Channel compliant.
2. Tested with a PRBS 2
1. Gigabit Ethernet and 1x/2x/4x Fibre Channel compliant.
2. Tested with a PRBS 2
7
-1 test pattern.
3.
Distances are based on FC-PI-2 Rev. 10.0 and IEEE 802.3 standards.
VI.
Environmental Specifications
These Finisar 1310nm Commercial Temperature SFP transceivers have an operating
temperature range from –10°C to +70°C case temperature.
temperature range from –10°C to +70°C case temperature.
Parameter Symbol
Min
Typ
Max
Units
Ref.
Case Operating Temperature
T
op
-10 70 °C
Storage Temperature
T
sto
-40 85 °C
VII. Regulatory Compliance
Finisar transceivers are Class 1 Laser Products and comply with US FDA regulations.
These products are certified by TÜV and CSA to meet the Class 1 eye safety
requirements of EN (IEC) 60825 and the electrical safety requirements of EN (IEC)
60950. Copies of certificates are available at Finisar Corporation upon request.
These products are certified by TÜV and CSA to meet the Class 1 eye safety
requirements of EN (IEC) 60825 and the electrical safety requirements of EN (IEC)
60950. Copies of certificates are available at Finisar Corporation upon request.