Toshiba R30-A Manuale Utente
56
Getting Started
Removing a memory module
Always make sure your computer and AC adaptor have
adequate ventilation and are protected from overheating
when the power is turned on or when an AC adaptor is
connected to a power outlet (even if your computer is in
Sleep mode). In this condition, observe the following:
adequate ventilation and are protected from overheating
when the power is turned on or when an AC adaptor is
connected to a power outlet (even if your computer is in
Sleep mode). In this condition, observe the following:
❖
Never cover your computer or AC adaptor with
any object.
any object.
❖
Never place your computer or AC adaptor near a
heat source, such as an electric blanket or heater.
heat source, such as an electric blanket or heater.
❖
Never cover or block the air vents including those
located at the underside of the computer.
located at the underside of the computer.
❖
Always operate your computer on a hard flat
surface. Using your computer on a carpet or other
soft material can block the vents located at the
underside of the computer.
surface. Using your computer on a carpet or other
soft material can block the vents located at the
underside of the computer.
Overheating your computer or AC adaptor could cause
system failure, computer or AC adaptor damage or a fire,
possibly resulting in serious injury.
system failure, computer or AC adaptor damage or a fire,
possibly resulting in serious injury.
7
Reconnect the cables.
8
Restart the computer.
TECHNICAL NOTE: You must have at least one memory
module installed for the computer to work.
module installed for the computer to work.
Checking total memory
When you add or remove a memory module, you can check
that the computer has recognized the change. To do this:
that the computer has recognized the change. To do this:
Press the (
) +
X
keys, and then click
System
.
The
System
window appears.
Installed memory
(RAM)
is displayed below the System heading.
If the computer does not recognize the memory
configuration, turn off the computer and remove the memory
module slot cover (complete steps
configuration, turn off the computer and remove the memory
module slot cover (complete steps
-
10
in
), and then check that the
module is inserted completely into the socket and lined up
squarely with the socket latches.
squarely with the socket latches.