TP-LINK TL-WPA4220 Manuale Utente

 

5

 

There are four physical items on this device.   

 

Wi-Fi/Wi-Fi 

Clone Button 

Press the button for 2 seconds to start Wi-Fi Clone. 
Press the button for 5 seconds to enable or disable the wireless function. 

Ethernet Port  Two 10/100Mbps Ethernet port connected to PC LAN card or broadband device. 

Reset Button 

Press the button more than 5 seconds, the device will restore to its factory 
defaults. 

Pair Button 

Pair buttons are used to secure a powerline network. 

)

1.  If you press the Pair button for more than 10 seconds, the extender will leave the network it is 

associated with and its network name assumes a random value.   

2.  For detail information about the Reset button and Pair button, please refer to 

Chapter 5 Pair 

Buttons

.  

Please first make sure that your PC can successfully access the Internet via the router. Then connect 
the powerline devices by following the instructions below.     

This section describes how to connect the powerline extender into your existing network. Follow the 
procedures described below: 

1． Connect one end of an Ethernet (RJ45) cable to the Ethernet port of the powerline extender or a 

compatible powerline adapter like TL-PA4010.   

Wi-Fi/Wi-Fi Clone Button 

Ethernet Port 

Pair Button 

Reset Button