Trimble Outdoors r7 Manuale Utente

1 3       Setting up the Receiver

1 1 8      Trimble R7/R8 GPS Receiver User Guide

The following guidelines apply whenever you set up your receiver for 
operation:

•

When plugging in a Lemo cable, make sure that the red dots on 
the receiver port and the cable connector line up. Never use 
force to plug cables in, as this may damage the connector pins.

•

When disconnecting a Lemo cable, grasp the cable by the 
sliding collar or lanyard and pull the cable connector straight 
out of the port. Do not twist the connector or pull on the cable 
itself.

•

To securely connect a TNC cable, align the cable connector 
with the receiver receptacle, then thread the cable connector 
onto the receptacle until it is snug. 

•

To insert the internal battery place the battery in the battery 
compartment, ensuring that the contact points are in the correct 
position to align with the contacts in the receiver. Slide the 
battery and compartment as a unit upward into the receiver until 
the battery compartment latches are locked into position.

Figure 13.3 shows the pole-mounted setup for the Trimble R8 
receiver. To mount the receiver on a range pole:

1.

Thread the unit onto the range pole.

2.

Attach the controller bracket to the pole.

3.

Insert the controller into the bracket.