Trimble Outdoors r7 Manuale Utente

1 8       Default Settings

1 6 0      Trimble R7/R8 GPS Receiver User Guide

To reset the Trimble R8 receiver to its factory defaults, do one of the 
following:

•

Press and hold down 

p on the receiver for 15 seconds.

•

In GPS Configurator, select Connect to Receiver and then click 

 in the General tab.

The factory defaults specified above are applied whenever you start 
the receiver. If a Power Up file is present in the receiver, its settings 
are applied immediately after the default settings, so you can use a 
Power Up file to define your own set of defaults.

When you turn the receiver off, any changes that you have made to 
logging settings are lost and these settings are returned to the factory 
defaults. Other settings remain as defined in the Current file. The next 
time you turn on the receiver, the receiver checks for a Power Up file 
and, if one is present, applies the settings in this file.

p

you changed the receiver settings by 
applying an application file

the factory defaults

the last settings used

you changed the receiver settings using 
configuration software

the factory defaults

the last settings used

there is a Power Up application file in the 
receiver

the factory defaults, or 
those in the Power Up 
file

a

a

A factory default setting is used only if the setting is not defined in the Power Up file.

the last settings used, 
or those in the Power 
Up file