CRU RAX840-IR 40457-1630-0100 Manuale Utente
Codici prodotto
40457-1630-0100
CRU
2.2 Check the accessories with your RAX-IR.
Please contact CRU if any parts are missing or
damaged. The box should contain the following items:
R A X 8 4 0 - I R Q u i c k S t a r t G u i d e A 9 - 8 4 0 - 0 0 0 4 - 1 R E V 1 . 0
- 3 -
NOTE: If any of the drives are inaccessible after
powering on the unit, try the following steps:
1. Turn off the power.
2. Remove the drive(s) in question.
3. Reinsert the drive(s).
4. Turn on the power.
powering on the unit, try the following steps:
1. Turn off the power.
2. Remove the drive(s) in question.
3. Reinsert the drive(s).
4. Turn on the power.
Accessories
Quantity
Ethernet Cables
2
Power Cables
2
Packet of Keys
1
Manual and Warranty Info
1
2.3 Hard Drive Installation
a)
Pull the ejection handle on the TrayFree
bay to open the bay door.
b)
Insert a bare SATA hard drive into the bay.
Make sure it is label-side to the left with the
SATA connection on the drive inserted first.
SATA connection on the drive inserted first.
c)
Shut the bay door.
d)
You can optionally secure each bay door. Doing so is not necessary to operate RAX.
Insert an RAX Key into its key lock and turn it 90 degrees clockwise.
2.4 Tips for mounting RAX840-IR
Use a support system to mount the unit. RAX840-IR requires slide rails or other support
system to be rack-mounted. The front mounting brackets will not allow the unit to be mounted
without additional support.
without additional support.
Operating temperature: Ensure that the unit is mounted in a room that is kept below 40° C (104°
F) and that the unit receives proper air flow.
Make sure that the unit is level before securing it into place.
Connections: Do not overload the supply circuit when connecting the equipment and ensure that
the unit is properly grounded.
3. Setting up Your RAX
The steps below explain how to get your RAX ready to use. If you purchased your RAX pre-configured,
you may skip step 3.
3.1 Connecting RAX to your network (or computer) for configuration.
a)
Plug an ethernet cable into the “Config GUI” port on the rear of RAX.
b)
Connect the other end of the ethernet cable to your network. Usually, this means plugging it
into a router or hub. In an office environment, you may have a network jack built into your office
wall. If a network connection is not available, you can connect the ethernet cable directly to an RJ45
(ethernet) port on your computer.
wall. If a network connection is not available, you can connect the ethernet cable directly to an RJ45
(ethernet) port on your computer.
c)
Connect the power cables to the rear of the RAX and to a grounded electrical outlet.
d)
Turn on the RAX unit’s power using the switches on the rear panel and on the front of the unit..