Smart FSSBID 100 Manuale Utente

1010651 Rev C1

A S S E M B L I N G   Y O U R   S M A R T   M O B I L E   S T A N D

Things to Consider When Assembling Your 
SMART Mobile Stand

•

Two people are required to safely assemble your SMART Mobile Stand 

and to mount or remove your flat-panel display and your SMART Board 

interactive display frame or SMART Board for Flat-Panel Displays 

interactive overlay.

•

Lock the casters before installing or working with your flat-panel display 

on your SMART Mobile Stand, or adjusting its height.

•

To prevent injury, be aware of crush and pinch locations on the product 

(marked with the crush symbol) during assembly and use. 

•

Do not rest your hand on the stand’s universal mount or under the interactive 

product’s pen tray or pencil ledge while adjusting the height of your 

SMART Mobile Stand.

•

Use the SMART Mobile Stand’s three grab bars to move the unit. 

Do not press, pull or push on the flat-panel display, interactive overlay 

or display frame, cabinet, doors, rear access panel plastics or 

vertical brackets.

•

Before moving your SMART Mobile Stand, make sure that you unlock the 

casters. These casters are designed to roll on common indoor surfaces. 

While you move the unit, your view may be partially obstructed. 

Be aware of surrounding obstacles.

To prevent damage to your power and extender cables, secure them to your 

mobile floor stand as instructed in the SMART Mobile Stand for Interactive 

).

•

You will require ample work space to assemble your SMART Mobile Stand. 

•

Do not set up or use your SMART Mobile Stand in an area with excessive 

levels of dust, dirt, humidity or smoke.

•

If you received an IEC power bar with your SMART Mobile Stand and you 

need to ground this power bar, use a self-tapping screw (not included) 

to secure its ground wire to the base sheet metal of your stand. Use the small 

hole located on the right side of the power bar (when viewed from the back) 

for this purpose.