Zebra HW46211 Manuale Utente
13185L-002 Rev. A 1/24/06
110XiIIIPlus Maintenance Manual
Page 4-93
Maintenance
Section 4
10. Reconnect the AC power cord and data cable.
11. Restore power and turn the printer On (l).
Adjust Rewind Mode
The Rewind Option Kit usually requires some adjustments to prevent printing problems
such as ribbon wrinkle, noncentered labels, and tearing of the media. Print a number of
test labels and use the following procedures to correct any problems.
Adjust Tracking
Refer to
1. If the media walks from side to side or tears or wrinkles against the backing plate on
the media rewind spindle, it may be necessary to adjust the position of the rewind
plate assembly mounted on the front of the printer or the rewind spindle assembly.
plate assembly mounted on the front of the printer or the rewind spindle assembly.
2. Remove the rewind plate assembly from the front of the printer and loosen the nuts
securing the hook plate to the rewind plate.
3. Move the outer end of the hook plate up to force the media to wind closer to the
large backing plate on the rewind spindle.
or
Move the outer end down to force the media away from the backing plate.
or
Move the outer end down to force the media away from the backing plate.
4. Reinstall the rewind plate on the front of the printer and print a number of test
labels. If problems persist, adjust the hook plate position again.
5. If the media cannot be made to track correctly after making this adjustment, check
the distance from the backing plate to the main frame. This dimension is set at the
factory and should be 0.550 in.
factory and should be 0.550 in.
± 0.020 in. (14 mm ±0.5 mm). If the distance needs
.
6. Loosen the set screws in the collar located inside the rewind spindle assembly near
the backing plate. The set screws are accessible through a single hole in the rewind
spindle assembly. Reposition the backing plate as required and retighten the set
screws in the collar.
spindle assembly. Reposition the backing plate as required and retighten the set
screws in the collar.
7. Perform the rewind plate assembly adjustment in steps 1 and 2 until the desired
results are achieved.
Figure 4-63. Adjust the Rewind Spindle Assembly Position
Collar
Tracking Plate
1/16 in.
Allen Wrench