Cisco TRC5 CTS-RMT-TRC5= Manuale Utente
Codici prodotto
CTS-RMT-TRC5=
33
Deployment Details
August 2012 Series
33
Step 9:
From the EX 90 in-Touch panel, select the red
END
button to hang
up the call.
Step 10:
On the Profile remote, press the
Red
end call button, and then
select
Disconnect 8831234
to hang up the call.
Step 11:
Disconnect the other endpoints, as required.
The reservationless conference creation and calling is complete.
Procedure 2
Configure scheduled conferences
Scheduled conferences are created and scheduled on Cisco MCU. The
endpoints can call into the conference, or the MCU can dial the endpoints at
the start of the meeting. With either method, the MCU registers the confer-
ence ID with Cisco VCS for the timeframe of the meeting. A permanent
meeting can also be created that reserves the resources of a particular
meeting and can be used at any time by the participants.
endpoints can call into the conference, or the MCU can dial the endpoints at
the start of the meeting. With either method, the MCU registers the confer-
ence ID with Cisco VCS for the timeframe of the meeting. A permanent
meeting can also be created that reserves the resources of a particular
meeting and can be used at any time by the participants.
Scheduled conferences have a prefix of 884. This allows them to be dif-
ferentiated from the reservationless conferences, which start with 883. In
this example, a weekly call-in conference will use the ID of 8841234 and a
call-out conference will use 8846789.
ferentiated from the reservationless conferences, which start with 883. In
this example, a weekly call-in conference will use the ID of 8841234 and a
call-out conference will use 8846789.
If you want Cisco MCU to call the participants at the beginning of the meet-
ing, the endpoint information is entered into the MCU ahead of time. You add
an SIP endpoint to the MCU before creating the conferences.
ing, the endpoint information is entered into the MCU ahead of time. You add
an SIP endpoint to the MCU before creating the conferences.
Step 1:
Open a browser window, and enter
10.4.48.135
(the IP address of
the Cisco MCU).
Step 2:
Click
Log in
, enter the following values, and then click
OK
.
• Username—
admin
• Password—
[password]
Step 3:
Navigate to
Home > Endpoints
, and then click
Add SIP
.
Step 4:
On the SIP Endpoint tab, enter the following values, and then click
Add endpoint
:
• Name—
85104600
• Call-out parameters > Address—
85104600@cisco.local
• Select—
Use SIP registrar
• Call-in match parameters > Username—
85104600@cisco.local
Step 5:
Add as many SIP endpoints as needed by repeating Step 3
and
The next set of steps creates a scheduled conference for call-in
participants. Use this type of conference when you are not sure
how many people will attend. Just like an audio conference, the
resources are reserved on the bridge for the duration of the
meeting. If participants do not call in, the ports are not used.
participants. Use this type of conference when you are not sure
how many people will attend. Just like an audio conference, the
resources are reserved on the bridge for the duration of the
meeting. If participants do not call in, the ports are not used.
Tech Tip
Step 6:
Navigate to
Home > Conferences > Conference List,
and then
click
Add new conference.