IBM Flex System V7000 Expansion Enclosure 4939H29 Manuale Utente
Codici prodotto
4939H29
Chapter 4. IBM Flex System V7000 Storage Node Initial Configuration
171
Draft Document for Review January 29, 2013 12:52 pm
8068ch04-Initial Config.fm
Figure 4-28 Change Service IP via management GUI procedure
Change Service IP via CMM
If CMM in the chassis is operating and reachable, you can use the CMM to change the
Service IP address of a node canister, as shown in Figure 4-29 on page 172.
Service IP address of a node canister, as shown in Figure 4-29 on page 172.
1. Open the CMM and navigate to the Chassis Management
Component IP
Configuration page
2. In the list of Storage Nodes, click on the name of the node canister.
3. In the IP address Configuration panel, click the IPv4 tab.
4. Select Node_Service_If as the Network Interface and select the Configuration Method
3. In the IP address Configuration panel, click the IPv4 tab.
4. Select Node_Service_If as the Network Interface and select the Configuration Method
you wish to use. If the selected Configuration Method is to Use Static IP address (as
shown in Figure 4-29 on page 172), type the Static IP address, Subnet Mask, and
Gateway address for the New Static IP Configuration.
shown in Figure 4-29 on page 172), type the Static IP address, Subnet Mask, and
Gateway address for the New Static IP Configuration.
5. Click Apply and then Close
Note: If, for example, the canister has failed to obtain a DHCP address and a default
Service IP address in the range between 192.168.70.131 and 192.168.70.144 is displayed,
the canister has failed to obtain a DHCP address.
Service IP address in the range between 192.168.70.131 and 192.168.70.144 is displayed,
the canister has failed to obtain a DHCP address.
4
3
1
2