Tandberg Data SATA DLT-V4 Internal Black 7301709200 Manuale Utente
Codici prodotto
7301709200
Chapter 2 Installing the Tape Drive
Installing the Tabletop SCSI Tape Drive
DLT-V4 Product Manual
9
Figure 2 SCSI ID Selector
Switch
Switch
Connecting the SCSI
Interface Cables
Interface Cables
2
In the final installation stage, you connect the SCSI and power cables to
the tape drive.
To connect the SCSI and power cables to the tape drive, follow these
steps:
1
Shut down the operating system and power down the server or
workstation.
2
Power off all peripheral devices, such as printers and other SCSI
devices.
3
Obtain a SCSI cable with an open 68-pin, high-density connector.
4
Connect one end of the SCSI cable to one of the connectors on the rear
panel of the tape drive as shown in
. Either SCSI connector
works equally well.
does not show a terminator because
none of the three tape drives in the illustration are at the end of the
SCSI bus.
Note:
If the selected server or workstation does not already have an
installed SCSI host adapter, you will need to install one. For
more information on SCSI host adapter requirements, see
Caution:
Do not go to step
until you have completed steps
. Failure to follow these instructions may result
in damage to the tape drive or other devices.
Press here to decrease
SCSI ID
Press here to increase
SCSI ID