Salicru SPS.16.STS 658CA-01 Dépliant
Codici prodotto
658CA-01
UNINTERRUPTIBLE POWER SUPPLY (UPS)
Break Before Make.
Automatic backfeed protection, as per standard EN 62310-1.
Overloading and short-circuit protection in both mains (using
accessible fuses and 10 A thermal relays).
Redundant internal power supply (from mains 1 and 2).
Alternating current detector (voltage and current detector).
Output detector (current detector).
Control panel with LED.
Auxiliary contact for external RPO.
IP30 protection index.
The SPS.16.STS can transfer with P/N input wiring error.
The two system inputs can be different phases of the same three-
phase N/R and N/S mains.
Audible alarm silencer.
Automatic backfeed protection, as per standard EN 62310-1.
Overloading and short-circuit protection in both mains (using
accessible fuses and 10 A thermal relays).
Redundant internal power supply (from mains 1 and 2).
Alternating current detector (voltage and current detector).
Output detector (current detector).
Control panel with LED.
Auxiliary contact for external RPO.
IP30 protection index.
The SPS.16.STS can transfer with P/N input wiring error.
The two system inputs can be different phases of the same three-
phase N/R and N/S mains.
Audible alarm silencer.
The SALICRU SPS.16.STS is basically an automatic, single phase switch with two input AC lines, which uses two sine-wave power supply
sources to provide output voltage to load/s.
sources to provide output voltage to load/s.
The SPS.16.STS is factory programmed with mains 1 as priority and mains 2 as reserve. Users can change this using the communication
software. Each time the SPS.16.STS is started, the system will start up with the criteria established the last time it was programmed.
software. Each time the SPS.16.STS is started, the system will start up with the criteria established the last time it was programmed.
It is possible to switch from mains 1 to mains 2 or vice versa using the BP2 pushbutton, and this change is recorded in the internal memory.
The power supply of the load/s is transfered from one mains to the other if the voltage and/or frequency of the priority source is off-margins.
The power supply of the load/s is transfered from one mains to the other if the voltage and/or frequency of the priority source is off-margins.
The LEDs on the control panel report the state of the equipment and operation at all times, and this panel is an easy-to-understand, practical
interface for any operator.
interface for any operator.
SPS.16.STS: Redundancy in power supply sources
PERFORMANCES
APPLICATIONS: A reliable, cheap and simple solution
SPS.16.STS
AUTOMATIC TRANSFER SYSTEM
SPS.16.STS
U N I N T E R R U P T I B L E P O W E R S U P P L I E S ( U P S )
+ L I G H T I N G F L O W D I M M E R S TA B I L I S E R S + V O LTA G E S TA B I L I S E R S & P O W E R L I N E C O N D I T I O N E R S + D C P O W E R S Y S T E M S + S TAT I C I N V E R T E R S + P H O T O V O LTA I C I N V E R T E R S