Brodit ProClip 530619 530619 Dépliant
Codici prodotto
530619
Charging Specifications
Lithium charging is based on CVCC (Constant Voltage Constant Current). The charging procedure is as
follows:
follows:
If the battery is empty or has low charge a constant current charges the battery until the cell voltage reaches
8,4V. The LED emits red light. Hereafter the charge continues until the current goes down to 0A. The battery
is now full and stays fully charged. A special designed voltage controller is monitoring that the cell voltage is
within limit. The LED emits green light.
8,4V. The LED emits red light. Hereafter the charge continues until the current goes down to 0A. The battery
is now full and stays fully charged. A special designed voltage controller is monitoring that the cell voltage is
within limit. The LED emits green light.
If the battery is used without disconnecting the charger, current is supplied directly resulting in a fast recovery.
Battery Chemistry
Li-ion or Li-Poly batteries
Input Voltage
11-30 V
Charging Voltage
8.4 V
Timer for Max. Charging Time
Automatic, stops at 8.4 V
Max. Charging Time
2-3 hours depending on battery capacity
Rapid Charge
1,2 A +/- 5%
Trickle Charge
0 to 50 mA
LED Charging Indicator
LED Red to Green indicator
Operating Temperature
-40° C to + 50° C / -40° F to 122° F
(can be restricted by battery chemistry)
Temperature Control
Controlled by battery and charger
RoHS Compliant
Yes
Input Transient Protected
Withstands +150V & -450V.
A 2,5A fuse is mounted on the incoming supply.
A 2,5A fuse is mounted on the incoming supply.
Output Short Circuit Protected
The charger will supply a maximum current of 1,2 A which protects
both the charger and the connected equipment. The current limit is
set to standards of the producer and shall not be higher.
both the charger and the connected equipment. The current limit is
set to standards of the producer and shall not be higher.
Compatible batteries
PMNN4065, PMNN4066